Engine Oil Pan
Show/hide table
| |
| 图 1 | g02632177 |
Show/hide table
| 271-5761 油底壳总成技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| 1 | 1 | 213-0677 液位开关 | 拧紧至扭矩为 |
| 2 | 1 | 109-5839 排放塞 | 组装前，用清洁的发动机机油润滑螺纹。
拧紧至扭矩为 |
Show/hide table
| |
| 图 2 | g02632176 |
Show/hide table
| 271-5761 油底壳总成技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| - | - | - | 组装发动机油底壳期间使用以下步骤： |
| - | - | - | 油底壳的密封表面应没有机油、碎屑、密封垫材料或任何其他密封胶。 |
| - | - | - | 油底壳必须在涂抹密封胶的 10 分钟内组装并紧固至缸体。 |
| - | - | - | 1. 将 前壳体和缸体前部的连接点。 飞轮壳和缸体后部的连接点。 将一道密封胶涂覆到密封垫或壳体表面。 在 T 形接头位置，胶条应覆盖整个跨度。 |
| 3 | 40 | 0S-1571 螺栓 | 2. 将螺栓 1 至螺栓 40 按图 2 中所示的数字顺序拧紧至 |
| 3. 将螺栓 1 至螺栓 40 按图 2 中所示的数字顺序再次拧紧至 |
|||
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Boost Pressure Sensor
C15 Petroleum Generator Set Engines Speed/Timing Sensor
2010/06/25 New Liner Seals Are Used and Inserts Are Available for All 3500 Engines {1201}
2013/01/16 New Liner Seals Are Used and Inserts Are Available for All 3500 Engines {1201}
C175-16 Petroleum Generator Set Engines Monitoring System
C11 and C13 Engines Piston and Rings
C13, C15, and C18 Tier 4 Interim Engines Configuration Parameters
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pump
C13 Industrial Engines Temperature Sensor (NOx Reduction System) - Cooled Diesel Exhaust Gases
797F Off-Highway Truck Power Train Gear Pump (Rear Axle Lubrication) - Assemble
797F Off-Highway Truck Power Train Gear Pump (Rear Axle Lubrication) - Disassemble
TH55FT-E70 and TH55FT-E90 Transmissions Component Location
C9.3 Tier 4 Final Engines Belt Tensioner
2010/03/25 An Updated Fuel Pressure Is Used In System Operation, Testing and Adjusting Manuals For C27 and C32 Engines {1250, 1256}
2010/03/25 An Updated Fuel Pressure Is Used In System Operation, Testing and Adjusting Manuals For C27 and C32 Machine Engines {1250, 1256}
EMCP4.3/4.4 Electronic Control Module (Generator Set)
C15 and C18 Engines for Caterpillar Built Machines Compression Brake
797F Off-Highway Truck Power Train Gear Motor (Rear Axle Lubrication) - Remove and Install
C15 and C18 Industrial Engines Camshaft
C15 and C18 Engines for Caterpillar Built Machines Camshaft
797F Off-Highway Truck Power Train Gear Motor (Rear Axle Lubrication) - Disassemble
797F Off-Highway Truck Power Train Gear Motor (Rear Axle Lubrication) - Assemble
C15 Engine for Caterpillar Built Machines Engine Design
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Cooler - Remove and Install