Air Shutoff - Assemble
Assembly Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 1P-0510 | Driver Gp | 1 |
| B | 9S-3263 | Thread Lock Compound | - |
| C | 8H-8581 | Feeler Gauge | 1 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) to install bearings (3) and seal (5) in air shutoff housing (4) .
Show/hide table
 | |
| Illustration 1 | g01184781 |
Show/hide table
 |
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
 |
- Lubricate the shaft assembly for air shutoff (6) lightly with glycerin prior to installation. Install the shaft assembly for air shutoff (6) in air shutoff housing (4) .
- Apply Tooling (B) to bolts (1). Reposition the shaft assembly for air shutoff (6) in order to install valve assembly (2). Position valve assembly (2) and install bolts (1) .
Note: After installation of valve assembly (2), the clearance between valve assembly (2) and air shutoff housing (4) must not exceed 0.08 mm (0.003 inch). Use Tooling (C) to check the clearance.
Caterpillar Information System:
3126B Petroleum Engine Air Shutoff - Disassemble
2005/07/01 Diagnostic Codes for the Fuel Pressure Sensor {1718, 7620}
C6.6 Engines for Caterpillar Built Machines Crankshaft Seals
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Assemble
3456 Generator Sets Manual Stop Procedure
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Device Bus Network - Modbus Communications
3456 Generator Sets Starting the Engine - EMCP 3 (If Equipped)
3618 Engine Auxiliary Water Pump - Assemble
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Disassemble
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Install
C-12 Generator Set Engine CID 0091 FMI 08 Throttle Position signal abnormal
C15 On-Highway Engine Fuel System - Prime
784C and 785C Off-Highway Truck/Tractors Match Tire Size - Dual Tire Configuration
3126B Petroleum Engine Air Shutoff - Install
2005/07/18 A Improved Gasket is Now Available {1151, 1162}
Supplemental Parts and Service Information for the C18 Marine Propulsion Engine {1901, 7470} Supplemental Parts and Service Information for the C18 Marine Propulsion Engine {1901, 7470}
2005/07/01 A Improved Gasket is Now Available {1151, 1162}
C7 and C9 On-Highway Engines Engine Rating Parameters
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0590 - FMI 12
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0700 - FMI 02
G3500 Engines Model View Illustrations
C7 and C9 Marine Engines Engine Cranks but Will Not Start
C13 and C15 On-highway Engines ECM Memory - Test
3126B Generator Set Engine CID 0164 FMI 02 Injector Actuation Pressure signal erratic