Water Outlet Manifold - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal.
- Remove clamp (1) for the boost line.
Show/hide table
Illustration 1 | g00553901 |
- Loosen clamp (2) and disconnect hose (3) from the water pump.
- Remove seven bolts (4) from water temperature regulator housing (5) .
Show/hide table
Illustration 2 | g00553902 |
- Remove water temperature regulator housing (5) and the gasket.
Caterpillar Information System:
Generator Set Control Panel for Switchgear Conversion Accessing Diagnostic Information
3408E and 3412E Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
797 Off-Highway Truck Hydraulic System Relief Valve (Hoist)
3408E and 3412E Engines for Caterpillar Built Machines Front Cover - Remove
Generator Set Control Panel for Switchgear Conversion Units Mode
3054 and 3056 Industrial and Generator Set Engines Engine Oil Pump
3054 Engine for Caterpillar Built Machines Crankshaft Pulley - Remove and Install
3608 Engine Engine Oil Pan - Disassemble
Generator Set Control Panel for Switchgear Conversion Tattletale Mode
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Install
3054 Engine for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install
G3606 and G3608 Engines Engine Oil Pan - Install
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Install
SR4 HV and SR4B HV Generators Insulation - Test
Generator Set Control Panel for Switchgear Conversion Troubleshooting Diagnostic Codes
3054 Engine for Caterpillar Built Machines Cylinder Liner - Remove
3054 Engine for Caterpillar Built Machines Cylinder Liner - Install
Generator Set Control Panel for Switchgear Conversion Initial Troubleshooting Procedure
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove
Generator Set Control Panel for Switchgear Conversion LH/RH Switch - Troubleshoot
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Install
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
Control Console For CPS361 Pumper, Cement General Information
3054 Engine for Caterpillar Built Machines Engine Oil Filter Base - Assemble