Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Illustration 1 | g00815156 |
The fuel tank drain plug is located on the bottom of the fuel tank. Water and sediment can be drained from the tank by loosening the plug. Do not remove the plug.
- Loosen the drain plug. Allow the water and the sediment to drain into a suitable container and then tighten the drain plug.
- The fuel tank filler cap is located at the left side of the machine. Unlock the protection cover. Remove the fuel cap slowly and add fuel to the fuel tank. Fill the fuel tank at the end of each day of operation. Filling the fuel tank after every day of operation will drive out moist air. Also, filling the tank helps to minimize condensation. Do not fill the tank to the top. Warm fuel expands and the fuel may overflow if the tank is overfilled.
Illustration 2 | g00815158 |
- Install the fuel cap.
- Never allow the fuel tank to run dry.