Service Tools     | |
---|---|
Part Number     | Part     |
* (1)     | Caterpillar Electronic Technician (ET)     |
6V-7070     | Digital Multimeter (Heavy Duty) (2)     |
9U-7330     | Digital Multimeter (2)     |
146-4080     | Digital Multimeter (2)     |
8T-3224     | Needle Tip Group     |
7X-1710     | Multimeter Probe Group     |
8T-8726     | "3 Pin Cable Assembly"     |
9U-7246     | Connector Repair Kit (Deutsch DT Type)     |
4C-3406     | Connector Repair Kit (Deutsch)     |
( 1 ) | In order to use the ET, order Special Publication, JERD2124, "ET Single Use Program License", Special Publication, JEHP1026, "Information and Requirements Sheet", and Special Publication, JERD2142, "Data Subscription". The Special Instruction, JEHP1026, "Information and Requirements Sheet" lists the required hardware and the features of the ET. |
( 2 ) | This tool can be used to measure the duty cycle and the frequency. |
For instructions on servicing Deutsch DT connectors, see Special Instruction, SEHS9516.
See Testing and Adjusting, "Using Caterpillar Electronic Technician (ET) to Determine Diagnostic Codes" for more information on Cat ET.
Use a calibrated digital multimeter for making continuity checks or for measuring voltage. For instructions about the use of the 6V-7070 Digital Multimeter, see Special Instruction, SEHS7734. The 7X-1710 Multimeter Probe is used to measure the voltage without disconnecting the connector. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a 3-pin breakout. The adapter cable is used for measurements in the sensor circuits.
Note: Except for harness tests, using continuity testers such as the 8T-0500 Continuity Tester or voltage testers such as the 5P-7277 Voltage Tester is not recommended.