Steering System
 | |
| Illustration 1 | g00634505 |
(1) Torque for one bolt ... 136 ± 20 N·m (100 ± 15 lb ft)
Note: Apply 4C-4032 Bearing Mount Compound (Loctite 271) to the threads before you install bolt (1) .
(2) Torque for one bolt ... 136 ± 20 N·m (100 ± 15 lb ft)
Note: Apply 4C-4032 Bearing Mount Compound (Loctite 271) to the threads before you install bolt (2) .
(3) Torque for Swivel Adapter ... 135 ± 15 N·m (100 ± 11 lb ft)
(4) Torque for Tee ... 135 ± 15 N·m (100 ± 11 lb ft)
(5) Torque for Seal Connector ... 150 ± 20 N·m (110 ± 15 lb ft)
(6) Torque for Seal Connector ... 150 ± 20 N·m (110 ± 15 lb ft)
(7) Torque for plug ... 230 ± 5 N·m (170 ± 3.7 lb ft)
Lines Group for Differential Lube Pump
 | |
| Illustration 2 | g00637871 |
(8) Torque for Tee ... 100 ± 10 N·m (74 ± 7.4 lb ft)
Implement Hydraulic System
 | |
| Illustration 3 | g00637884 |
(9) Torque for four hose clamps ... 11.2 ± 0.5 N·m (8.3 ± 0.4 lb ft)
(10) Torque for one bolt ... 120 ± 20 N·m (90 ± 15 lb ft)
Note: Apply 4C-4032 Bearing Mount Compound (Loctite 271) to the threads before you install bolt (9) .
(11) Torque for two clamps ... 11.2 ± 0.5 N·m (8.3 ± 0.4 lb ft)
(12) Torque for one elbow ... 135 ± 15 N·m (100 ± 11 lb ft)
(13) After initial assembly, use this fitting to bleed air from the load sensing signal line. While the engine is running at low idle, hold a control lever for a implement valve in the RAISE position. Hold this lever until a clear stream of hydraulic oil flows from a drain line that is attached to this fitting.