Oscillation Bearings - Lubricate
The fittings for the oscillation bearings are located near the center hitch.
Show/hide table
Illustration 1 | g00874241 |
Left Side |
Show/hide table
Illustration 2 | g00874242 |
Right Side |
- Wipe off the fittings before any lubricant is applied.
- Apply 1P-0808 Multipurpose Grease through one fitting on each side of the machine.
Caterpillar Information System:
69D, 769D , 773D, 773E, 776D, 777D, 784C, 785C, 785D, 789C, 789D, 793C and 793D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Braking System Speed Sensor - Adjust
784C and 785C Off-Highway Trucks Machine Systems Brake Valve (Parking and Secondary) - Assemble
793C Off-Highway Truck/Tractor Power Train Transmission, Rear Axle Housing, and Wheel Group - Install
69D and 769D Off-Highway Truck and 771D Quarry Truck Hydraulic System Electronic Control (Body Down or Up Switch)
784C and 785C Off-Highway Trucks Machine Systems Brake Valve (Parking and Secondary) - Disassemble
554 Forwarder and 574 Forwarder Hydraulic System Oil Level - Check
216 and 226 Skid Steer Loaders Machine Systems Pilot Hydraulic System
216 and 226 Skid Steer Loaders Machine Systems Interlock Manifold Valve
216 and 226 Skid Steer Loaders Machine Systems General Information
216 and 226 Skid Steer Loaders Machine Systems Diverter Valve
216 and 226 Skid Steer Loaders Machine Systems Bank Valve
561M Pipelayer Before Operation
24H Motor Grader Transmission Electronic Control System And Hydraulic Calibrations CID 0701 FMI 02 Speed Sensor (Transmission Output) Incorrect Signal - Test
554 Forwarder and 574 Forwarder Oscillation Lock Cylinder - Lubricate
69D and 769D Off-Highway Truck and 771D Quarry Truck Hydraulic System Control Valve (Hoist)
24H Motor Grader Transmission Electronic Control System And Hydraulic Calibrations CID 0739 FMI 03 Lamp (Differential Lock Indicator) Voltage Above Normal - Test
784C and 785C Off-Highway Trucks Machine Systems Valve (Suspension Cylinder Charging) - Disassemble
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Sampling Interval and Location of Sampling Valve
69D, 769D , 773D, 773E, 776D, 777D, 784C, 785C, 785D, 789C, 789D, 793C and 793D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Braking System System Schematic
784C and 785C Off-Highway Trucks Machine Systems Valve (Suspension Cylinder Charging) - Assemble
69D, 769D , 773D, 773E, 776D, 777D, 784C, 785C, 785D, 789C, 789D, 793C and 793D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Braking System Electronic Control Module (ECM) - Flash Program
CB-534C and CB-634C Vibratory Compactors Propel System Travel Speed - Test
D250E Series II and D300E Series II Articulated Trucks Power Train Relief Valve (Torque Converter Outlet) - Remove
D250E Series II and D300E Series II Articulated Trucks Power Train Relief Valve (Torque Converter Outlet) - Install