Fuel Filter Is Restricted
The Electronic Control Module (ECM) detects an abnormal fuel filter differential pressure.
Use this procedure to troubleshoot a problem with the fuel filters. Also, use this procedure if one of the following event codes are active or logged.
Show/hide table
J1939 Code and Description | CDL Code and Description | Comments |
---|---|---|
1382–15
Engine Fuel Filter (suction side) Differential Pressure : Data High - Least Severe |
E1129 (1)
Fuel Filter (suction side) Restriction |
For the primary fuel filters, the difference between the filtered fuel pressure and the unfiltered fuel pressure is greater than the trip point. |
5584-0
Engine Fuel Filter Degradation : High - most severe (3) |
E390 (3)
Fuel Filter Restriction |
For the secondary fuel filters, the difference between the filtered fuel pressure and the unfiltered fuel pressure is greater than the trip point pressure. |
5584-15
Engine Fuel Filter Degradation : High - least severe (1) |
E390 (1)
Fuel Filter Restriction |
For the secondary fuel filters, the difference between the filtered fuel pressure and the unfiltered fuel pressure is greater than the trip point pressure. |
5584-16
Engine Fuel Filter Degradation : High - moderate severity (2) |
E390 (2)
Fuel Filter Restriction |
For the secondary fuel filters, the difference between the filtered fuel pressure and the unfiltered fuel pressure is greater than the trip point pressure. |
- Codes
- Fuel filter
Note: Do not fill the canister or the fuel filter before installation. The fuel can carry debris into the fuel filter and the fuel system may be damaged. The electric priming pump is designed to purge the trapped air in the new filters.
Show/hide table
Troubleshooting Test Steps | Values | Results |
---|---|---|
1. Check for Codes A. Connect Cat® Electronic Technician (ET) to the service tool connector. B. Determine if a code is active or logged. |
Codes |
Result: A E390 or E1129 code is active or logged. Proceed to Test Step 2. |
2. Replace the Fuel Filters A. Replace the appropriate fuel filter elements for the code. B. Prime the fuel system. Refer to the Operation and Maintenance Manual for information. C. Restart the engine and check for an active event code for the filter that was changed. |
Fuel Filter |
Result: After starting the engine, the event code is no longer active for the filter that was changed. |
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).
Caterpillar Information System:
C7.1 Engines and Generator Sets Diagnostic Trouble Codes
C7.1 Engines and Generator Sets Configuration Parameters
C7.1 Engines and Generator Sets Electrical Connectors
C7.1 Engines and Generator Sets Diagnostic Capabilities
C7.1 Engines and Generator Sets Diesel Particulate Filter Regeneration
Electronic Control Module Serviceability for Certain Cat® Compact Retail Gas Generator Sets {1901, 1920} Electronic Control Module Serviceability for Certain Cat® Compact Retail Gas Generator Sets {1901, 1920}
C175-16 Oil and Gas Generator Set Fluid Recommendations
C175-16 Oil and Gas Generator Set Starting the Engine
Electronic Control Module Serviceability for Certain Cat® Compact Retail Gas Generator Sets {1404, 1901, 1920} Electronic Control Module Serviceability for Certain Cat® Compact Retail Gas Generator Sets {1404, 1901, 1920}
C7.1 Engines and Generator Sets Component Location
C7.1 Engines and Generator Sets System Overview
C7.1 Engines and Generator Sets Welding Precaution
C175 Oil&Gas Offshore Engine Fuel Rail Pressure Is High
C175 Oil&Gas Offshore Engine Fuel Rail Pressure Problem
C175 Oil&Gas Offshore Engine Fuel Control - Test
C175 Oil&Gas Offshore Engine Fuel Priming Pump - Test
C175 Oil&Gas Offshore Engine Injector Solenoid - Test
C175 Oil&Gas Offshore Engine Fuel Pump (High Pressure) - Replace
3500E Marine Engines Overhaul Recommendations
Installation Procedure for the TLV2 Seat Suspension Harness {1408, 7324} Installation Procedure for the TLV2 Seat Suspension Harness {1408, 7324}
New Software Is Now Used on Certain C27 and C32 Commercial Engines {1920} New Software Is Now Used on Certain C27 and C32 Commercial Engines {1920}
Ordering NOx Reduction System Coolers for C9.3, C13, C15, and C18 Engines {108G} Ordering NOx Reduction System Coolers for C9.3, C13, C15, and C18 Engines {108G}
C7.1 Engines and Generator Sets Event Codes
C175 Oil&Gas Offshore Engine Clean Emissions Module Has High Oxygen Level