Inlet Manifold Pressure - Test
通过比较现有进气歧管的压力与技术营销信息(TMI)中给出的信息,即可检查发动机的效率。 应在发动机功率下降,但是发动机又没有切实的故障迹象时进行本测试。
TMI 中列出了来自发动机测试单元的进气歧管压力数据。 此数据是在受控条件下收集的。 条件变化会导致结果变化。 请参阅 TMI 以了解详细信息。
这些条件发生任何变化都会使进气歧管压力产生变化。 外部空气可能比受控条件具有更高的温度和更低的大气压力。 这些条件会导致进气歧管压力测量值低于 TMI 中提供的压力。 外部空气如果气温低于,大气压力高于以上给出的数值的话会导致进气歧管压力测量值高于技术销售信息资料(TMI)中的压力。
注: 确保检查压力时进气和排气不受阻。
注: Caterpillar 电子技师(ET)可被用来检查进气歧管压力。
Show/hide table
所需工具     | |
---|---|
零件号     | 零件描述     |
1U-5470 或 198-4240     |
发动机压力表总成 或 数字压力指示器总成     |
Show/hide table
图 1 | g00293196 |
1U-5470 发动机压力表总成 |
有关使用 1U-5470 发动机压力表总成 所需的说明,请参阅专门说明书, SEHS8907, "使用 1U-5470 发动机压力表总成 "。 有关使用 198-4240 数字压力指示器总成 所需的说明,请参阅操作手册, NEHS0818, " 198-4240 数字压力指示器总成 的使用"。
Show/hide table
图 2 | g02684656 |
进气歧管测压点 |
使用下述程序测量进气歧管压力:
- 将进气歧管压力传感器从缸盖上拆下。
- 在缸盖的端口上安装一个 T 形管接头。
- 将压力传感器安装到 T 形管接头的一侧。
- 将 1U-5470 发动机压力表组 安装到 T 形管接头的另一侧。
注: 为使发动机正常工作,压力传感器必须重新安装到发动机的这个位置。
- 在类似于 TMI 给出的发动机状况下测量进气歧管压力。 记录数值。
- 比较步骤 5 中记录的数值与 TMI 中给出的压力值。
Caterpillar Information System:
C4.4 Engines for Caterpillar Built Machines Coolant Temperature Sensor
3406C Industrial Engine Reference Material
3516C Generator Set Engines Starting - Test
C4.4 Engines for Caterpillar Built Machines Boost Pressure Sensor
C4.4 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
TA19 M4WD Agricultural Transmission Transmission Clutches
TA19 M4WD Agricultural Transmission Hydraulic System Schematic
CG137-08 and CG137-12 Industrial Engines Sensor Signal (Analog, Passive) - Test
C15 Generator Set Refill Capacities
303.5E2, 304E2, 305.5E2 and 305E2 Mini Hydraulic Excavators Regulatory Information (Japan)
TA19 M4WD Agricultural Transmission Location of Hydraulic Components for Transmission System
C13, C15, and C18 Tier 4 Final Engines Water Pump
854K Wheel Dozer, and 992K and 993K Wheel Loaders Monitoring System Wiring Harness (Open Circuit) - Test
854K Wheel Dozer, and 992K and 993K Wheel Loaders Monitoring System Wiring Harness (Short Circuit) - Test
854K Wheel Dozer, and 992K and 993K Wheel Loaders Monitoring System Electrical Connector - Inspect
CG137-08 and CG137-12 Industrial Engines Sensor Supply - Test
C175-16 Generator Set Plate Locations and Film Locations
C175-16 Generator Set Emissions Certification Film
C175-16 Generator Set Engine Operation
TA19 M4WD Agricultural Transmission Transmission Power Flow
3500 Generator Sets Control Panel - Inspect/Test
A Service Replacement Air Filter for the Cab is Available for Certain Excavators and Mobile Hydraulic Power Units{734D} A Service Replacement Air Filter for the Cab is Available for Certain Excavators and Mobile Hydraulic Power Units{734D}
C175-16 Generator Set Fuel System - Prime
2011/08/12 Fuel Pressure Gauges Are Now Shipped Loose on Certain C9 Marine Engines {7456}