Electric Starting Motor
When the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ... Clockwise
Specifications
- System voltage ... 24 V
- Minimum operating voltage ... 8 V
The B+ terminal must be mounted below the horizontal at a maximum angle of ... 60 Degrees
No load performance at
- Speed ... 4060 rpm
- Current ... 142 amp
- Voltage ... 22.5 V
- Current ... 142 amp
Operating temperature range of the starting motor ...
Show/hide table
Illustration 1 | g02148181 |
(1) Battery terminal
- Maximum number of cable or wire terminals between the nuts ... 3
- Tighten the nut on the battery terminal to the following torque. ...
24 ± 2 N·m (18 ± 1 lb ft) - A maximum of two cable terminals can be larger than ... 0 AWG
- Tighten the nut on the battery terminal to the following torque. ...
(2) Solenoid mounting bolts
- Tighten the nut on the ground terminal to the following torque. ...
8.75 ± 1.05 N·m (77.44 ± 9.29 lb in)
(3) Switch terminal
- Tighten the nut on the switch terminal to the following torque. ...
2.25 ± 0.25 N·m (19.91 ± 2.21 lb in)
(4) Ground terminal
- Tighten the nut on the ground terminal to the following torque. ...
24 ± 2 N·m (18 ± 1 lb ft)
(A) Pinion engaged ...
(B) Pinion disengaged ...
Caterpillar Information System:
C4.4 (Mech) Marine Generator Set MCS-3 Fuel System Secondary Filter - Replace
C4.4 (Mech) Marine Generator Set MCS-3 Fuel System Primary Filter (Water Separator) Element - Replace - if Equipped
C4.4 (Mech) Marine Generator Set MCS-3 Engine Speed/Timing Sensor - Clean/Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Fuel System - Prime - Duplex Fuel Filter if Equipped
C4.4 (Mech) Marine Generator Set MCS-3 Engine Oil and Filter - Change - Duplex Oil Filters
C4.4 (Mech) Marine Generator Set MCS-3 Engine Oil and Filter - Change - Single Oil Filter
C4.4 Industrial Engine Fuel System - Prime
C4.4 (Mech) Marine Generator Set MCS-3 Generator Lead Connections
2010/04/30 A Rework Procedure Improves the Seal Assembly Performance in Hydraulic Cylinders on Cat Products {7562}
C15 and C18 Petroleum Generator Sets Customer Assistance
C13, C15, and C18 Tier 4 Final Engines Exhaust Diffuser Adapter
C9.3 Tier 4 Final Engines Diesel Particulate Filter Has Changed Regeneration Interval
C9.3 Engines for Caterpillar Built Machines Pressure Sensor (DPF) - Remove and Install
C27 Generator Set Engines Air Inlet and Exhaust System - Inspect
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C27 and C32 Tier 4 Engines Component Location
317-7492 Wireless Radio{7338} 317-7492 Wireless Radio{7338}
348-5430 Multi-Tool Gp 2 {0709, 0769, 0785} 348-5430 Multi-Tool Gp 2 {0709, 0769, 0785}
C9.3 Engines for Caterpillar Built Machines Pressure Sensor (ARD Combustion Air) - Remove and Install
C7.1 Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 Industrial Engine Accessory Drive
C4.4 Industrial Engine Accessory Drive - SAE "B"
525D, 535D, 545D, 555D Wheel Skidder Fuel System Primary Filter (Water Separator) Element - Replace
C4.4 Industrial Engine Air Compressor - Twin Cylinder Compressor