Water Lines
Show/hide table
| |
| Illustration 1 | g02108317 |
|
Right side view of engine | |
(1) Lubricate the bore of the O-ring seals lightly with 5P-3975 Rubber Lubricant.
Show/hide table
| |
| Illustration 2 | g02108293 |
|
Front view of engine | |
Show/hide table
| |
| Illustration 3 | g02108294 |
|
Tightening sequence | |
(2) Tighten the bolts in the numerical sequence to the following torque. Refer to Illustration 3 for the sequence. ...
(3) Assemble the gasket with the indexing tab toward right side of the engine.
Caterpillar Information System:
EMCP4.1/EMCP4.2 Kilowatt Relay Programming - EMCP 4.2 only
C18 Generator Set Aftercooler Condensate Drain Valve - Inspect/Clean
C27 and C32 Engines for Caterpillar Built Machines Coolant Contains Fuel
C27 and C32 Engines for Caterpillar Built Machines Coolant Contains Oil
C15 and C18 Industrial Engines Valve Mechanism Cover Base - Remove and Install
C13 Industrial Engines Alternator and Regulator
C27 and C32 Engines for Caterpillar Built Machines Cylinder Is Noisy
2010/02/22 Component Cleaners That Contain Trichloroethylene (TCE) Must Not Be Used On Electrical Connectors {0709}
C27 and C32 Engines for Caterpillar Built Machines Engine Does Not Crank
C27 and C32 Engines for Caterpillar Built Machines Engine Has Mechanical Noise (Knock)
C27 and C32 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable
C27 and C32 Engines for Caterpillar Built Machines Engine Shutdown Occurs Intermittently
G3500B Engines Water Lines
G3500B Engines Water Lines
G3500B Engines Water Lines
349F and 352F Excavators Access Door and Cover Locations
C27 and C32 Engines for Caterpillar Built Machines Alternator Problem - Charging Problem and/or Noisy Operation
2010/05/24 A New Turbocharger Is Used on Certain C18 Engines {1052, 1053}
EMCP4.1/EMCP4.2 Monitoring Software for Computer
349F and 352F Excavators Belt - Inspect/Adjust/Replace
2011/02/17 New Couplings Are Used for the Compressor Bypass on Some G3500 Engines {1803, 5510}
G3406 Engine Valve Stem Projection - Measure/Record
C4.4 Industrial Engine Configuration Parameters
2011/01/06 New Crankshaft for 3054C, 3054E, C4.4 and C4.4 (Mech) Engines {1201, 1202, 1205, 1218}