Procedure to Install Oil Pan{1302}
- Marine Engine:
- 3412B MARINE (S/N: 3JK1-UP)
- 3412E MARINE (S/N: 9KS1-UP)
- C32 MARINE (S/N: RXB1-UP; RNC1-UP; SLT1-UP; T3T1-UP)
- 3412E MARINE (S/N: 9KS1-UP)
Introduction
Do not perform any procedure in this Special Instruction until you read this information and you understand this information.
Safety Section
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants Contaminants may cause rapid wear and shortened component life. |
Required Parts
Use the 1U-7505 Hydraulic Jack .
Procedure
Show/hide table
Illustration 1 | g01194975 |
- Use 1U-7505 Hydraulic Jack to support engine oil pan (6). The weight of the engine oil pan (6) is approximately 22 kg (49 lb).
- Position the gasket and engine oil pan (6) on the engine. Install the bolts (5) .
- Install the bolts (7). Uniformly raise the oil pan into the correct position against the block and torque the bolts (7) to 15 N·m (11 lb ft).
- Apply final torque 47 N·m (35 lb ft) to the bolts (7) .
- Install the tube assembly (1) .
Show/hide table
Illustration 2 | g01194956 |
- Install the new O-ring seal on elbow (4) .
- Position the elbow (4). Install the bolt (2) and the washer (3) .
Note: If the oil pan drain plug was removed, then install the oil drain plug. Tighten the oil drain plug to a torque of 70 ± 10 N·m (52 ± 7 lb ft).
Caterpillar Information System:
C18 Industrial Engine Acceleration Is Poor or Throttle Response Is Poor
C18 Industrial Engine Configuration Parameters
2009/03/01 A New Fuel Enable Valve Is Available for On-Highway Engines {1274, 1380, 5479}
C18 Industrial Engine System Overview
C6.6 Marine Generator Set Engine Misfires, Runs Rough or Is Unstable
G3500B Engines Air Lines
793F and 797F Off-Highway Trucks Chassis Electronic Control System Event Code List
793F and 797F Off-Highway Trucks Chassis Electronic Control System Diagnostic Capabilities
793F and 797F Off-Highway Trucks Chassis Electronic Control System Electrical Component and Connector Locations
793F and 797F Off-Highway Trucks Chassis Electronic Control System Electronic Control Module (ECM) - Configure
2008/12/08 A New Torque Sequence for the Valve Cover Is Now Used {1107}
793F and 797F Off-Highway Trucks Chassis Electronic Control System Electrical Connector - Inspect
C18 Industrial Engine Engine Cranks but Does Not Start
C18 Industrial Engine Engine Misfires, Runs Rough or Is Unstable
C18 Industrial Engine Indicator Lamp - Test
3500B Locomotive Engines Turbocharger
C18 Industrial Engine Component Location
C18 Industrial Engine Diagnostic Code Cross Reference
793F and 797F Off-Highway Trucks Chassis Electronic Control System Using Advisor to Determine Diagnostic Codes
CX35-P800 Petroleum Transmission and CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages Torque Converter Housing
Possible Coolant Leaks in Certain 3500 Cylinder Heads{1100, 1395} Possible Coolant Leaks in Certain 3500 Cylinder Heads{1100, 1395}
C18 Industrial Engine Coolant Level Is Low
C18 Industrial Engine Engine Overspeeds
C18 Industrial Engine Fuel Pressure Is High