This event code will only be generated if the switch on the water separator filter is installed and correctly wired to the Electronic Control Module (ECM) and the customer programmable feature is enabled.
The ECM detects a fault with the water level in the fuel filter. A water level sensor may be installed in the fuel filter. If the water rises above a set level for more than thirty seconds, the ECM will generate this code. The code will become inactive when the switch has been immersed in fuel for 5 seconds.
Note: The code is generated only when the engine is running.
System Response:
The event code will be logged.
The warning light on the control panel will flash.
Possible Performance Effect:
E232-1
None
Troubleshooting:
Test Step 1.
Refer to Testing and Adjusting, "Fuel System - Inspect".
Results:
- OK - STOP