Transmission and Torque Converter - Separate
分离步骤
Show/hide table
| 需要的工具 | |||
| 工具 | 零件号 | 零件名称 | 数量 |
| A | 138-7574 | 连杆支架 | 2 |
| B | 1U-9200 | 杠杆式拔拉起重机 | 1 |
注: 分离变速箱装置前，断开所有的软管组件和线束组件。
- 在变速箱组件 (1) 下放置合适的垫块。
Show/hide table
 | |
| 图 1 | g01435282 |
- 将工具 (A) 和适当的起吊设备装在变矩器组件 (2) 上。 将工具 (B) 装在变矩器组件 (2) 上。 变矩器组件 (2) 的重量约为 1108 kg (2440 lb)。
Show/hide table
 | |
| 图 2 | g01435288 |
- 拆下螺栓 (3) 。
- 从变速箱组件 (1) 上分离变矩器组件 (2) 。
Show/hide table
 | |
| 图 3 | g01450203 |
Caterpillar Information System:
C9 Petroleum Engines Housing (Front) - Remove
2007/12/03 Improved PL1000T Hardware and Software is Now Available {7610}
C3.3 Industrial Engine Model View Illustrations
C4.4 Generator Set Engines Injector Data Incorrect - Test
G3520B Industrial Engines Diagnostic Trouble Codes
G3520B Industrial Engines Event Codes
3176C, 3406E and 3456 Industrial Engines ECM Does Not Communicate with Other Modules
3516B Engine for 994F and 994H Wheel Loaders Coolant Contains Oil
2007/11/26 Improved PL1000E Hardware and Software is Now Available {7610}
C9 Petroleum Engines Gear Group (Front) - Install
C9 Petroleum Engines Gear Group (Front) - Remove
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Parallel Setpoint Viewing OP2-3
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission and Torque Converter - Connect
C15 and C18 Petroleum Generator Sets Speed Sensor - Clean/Inspect
C9 Petroleum Engines Housing (Front) - Install
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Remove
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Install
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Disassemble
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Assemble
C4.4 Generator Set Engines Injector Solenoid Circuit - Test
C27 and C32 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Install
C9 Petroleum Engines Crankcase Breather - Remove and Install
G3600 Engines Sensor Signal (PWM) - Test
C9 Petroleum Engines Cylinder Block Cover - Remove and Install