Engine Overspeeds
Use this procedure in order to troubleshoot an engine overspeed or use this procedure if the following event code is active. Refer to Troubleshooting, "Event Code List" for information about event codes and the default trip points for these codes. You must access the monitoring system on Caterpillar Electronic Technician (ET) in order to view the current trip points for these codes.
Show/hide table
Event Code     | ||
---|---|---|
Code and Description     | Conditions which Generate this Code     | System Response     |
E362(1) Engine Overspeed     | The engine rpm has exceeded the trip point for engine overspeed for the delay time.     | The code is logged. The Electronic Control Module (ECM) will disable fuel injection for engine speeds that are above the trip point.     |
Probable Causes
- Intake air is combustible.
- Sudden drop of load
Recommended Actions
Intake Air is Combustible
Check for hydrocarbons in the surrounding atmosphere. Do not operate the engine in an environment with hydrocarbons in the surrounding atmosphere.
Sudden Drop of Load
Decrease the load on the engine gradually.
Caterpillar Information System:
C9 Agricultural Engine for Challenger Tractors Fuel Pressure Is High
C9 Agricultural Engine for Challenger Tractors Fuel Pressure Is Low
C9 Agricultural Engine for Challenger Tractors Coolant Level Is Low
C32 Marine Propulsion Engines Speed/Timing - Test
2007/07/09 A Gasket for the Cooling System has been Improved {1380, 7555}
3176C, 3406E and 3456 Industrial Engines Engine Does Not Crank
C15 and C18 Industrial Engines Engine Cranks but Does Not Start
C15 On-Highway Engine Combustion Head Group (ARD) - Remove and Install
3516C Locomotive Engine Model View Illustrations
3516C Locomotive Engine Electrical System
Procedure to Update the Head Gasket on the Air Compressor on Caterpillar On-Highway Engines{1803, 7555} Procedure to Update the Head Gasket on the Air Compressor on Caterpillar On-Highway Engines{1803, 7555}
C15 On-Highway Engine Combustion Body Group (ARD) - Install
C32 Marine Auxiliary Engines Speed/Timing - Test
3516B Engine for 994F and 994H Wheel Loaders Inlet Air Is Restricted
C9 Agricultural Engine for Challenger Tractors Coolant Temperature Is High
2007/07/23 A New Oil Line for the Turbocharger {1307}
2007/06/11 Troubleshooting the Wiring Harness for the Fuel Injector {1408}
C15 and C18 Petrolem Generator Set Engines ECM - Replace
C11 and C13 Petroleum Engines Electronics Grounding Stud - Inspect/Clean/Tighten
C32 Petroleum Engines Fan Drive Bearing - Lubricate
3176C, 3406E and 3456 Industrial Engines Factory Passwords
C18 Marine Engines Synchronization - Test
2007/05/21 A "Do Not Weld" Film is Used {7557}
2007/05/14 Do Not Allow the Engine Status Control Module to Overheat {1901, 7490}