Auxiliary Drive Pulley
Show/hide table
 | |
| Illustration 1 | g01373434 |
(1) Torque for the locknut ... 205 ± 7 N·m (150 ± 5 lb ft)
(2) Lubricate the bore of the O-ring seal lightly with clean engine oil or glycerin.
(3) Torque for the taperlock studs ... 27 ± 4 N·m (20 ± 3 lb ft)
(4) Lubricate the sealing lip of the lip type seal with the lubricant that is being sealed.
Caterpillar Information System:
C7 On-highway Engine Air Compressor
C32 Marine Engine Plate Locations and Film Locations
C18 Marine Engines Sensor Signal (Analog, Active) - Test
C13 Engine Fuel Pressure Sensor - Remove and Install
C13 Engine Air Pump (ARD Purge) - Install
Application and Instruction Guide for the Driveline PTO on CX28, CX31, and CX35 On-Highway Transmissions{1408, 3030, 3108} Application and Instruction Guide for the Driveline PTO on CX28, CX31, and CX35 On-Highway Transmissions{1408, 3030, 3108}
2007/04/30 An Improved Starting Motor is Now Available {1453}
C13 Engine Air Pump (ARD Purge) - Remove
C15 On-Highway Engine Clean Gas Induction Temperature Sensor - Remove and Install
C18 Marine Engines Engine Top Speed Is Not Obtained
C3.4 IND Industrial Engine Emissions Certification Film
3500C Marine Engines Engine Speed/Timing Sensor
3408B and 3408C Industrial and Marine Engines Auxiliary Drive Pulley
C32 Petroleum Engines Air Shutoff - Test
CX35 On-Highway Transmission Plate Locations and Film Locations
2007/04/30 Change to the Maintenance Interval Schedule {1100, 1102, 1121, 1123, 1210}
C18 Marine Engines Sensor Supply - Test
2007/05/14 Water Pump Weepage Versus Water Pump Leakage {1361}
2007/05/01 Water Pump Weepage Versus Water Pump Leakage {1361}
3500B Engines Fuel Filter Housing - Remove
3500B Engines Fuel Filter Housing - Install
C18 Marine Engines Indicator Lamp - Test
C15 On-Highway Engine Fuel Filter Base - Remove
G3500 Engines Safety Messages