Air Inlet Heater
Show/hide table
| |
| Illustration 1 | g01101444 |
|
Air inlet heater | |
(1) Torque for the nut ...
Note: Do not switch the positive wire and the negative wire. Reverse polarity could result in a blown fuse.
Note: During assembly of the air inlet heater to the inlet manifold and the air inlet elbow, clean the air inlet heater's joint faces with solvent. Apply 4C-9500 Quick Cure Primer to the joint faces. Allow the primer to air dry for a minimum of three to five minutes. Apply 1U-8846 Gasket Sealant to the joint face and spread the gasket maker uniformly. The heater must be assembled and tightened within ten minutes.
The 24 volt air inlet heater has the following functional requirements:
- 22 VDC at 86 amperes
- 1892 watts
Caterpillar Information System:
3126E and 3126B Commercial and Truck Engines Maintenance Interval Schedule - Engines with a Shallow Oil Sump
3126E and 3126B Commercial and Truck Engines Maintenance Interval Schedule - Engines with a Deep Oil Sump
C7 Engines for Caterpillar Built Machines Injection Actuation Pressure Sensor
C4.4 Industrial Engine Air in Fuel - Test
3500 Engines Water Lines
C7 On-highway Engine Air Inlet and Exhaust System - Inspect
Excessive Oil Consumption on C13 Truck Engines{1902, 7620} Excessive Oil Consumption on C13 Truck Engines{1902, 7620}
3500B and 3500C Marine Propulsion Engines MID 036 - CID 1249 - FMI 13 Secondary Throttle Position calibration required
C4.4 Marine Generator Set Starting the Engine - Protection and Paralleling Unit (PPU) Control Panel and Marine Certification Society (MCS) Control Panel (if equipped)
3500B and 3500C Marine Propulsion Engines MID 036 - CID 1249 - FMI 08 Secondary Throttle Position signal abnormal
3606 and 3608 Engines Water Temperature Regulator - Remove and Install
C4.4 Marine Generator Set Enclosure - Inspect
3500 Engines Turbocharger Oil Lines
3500 Engines Water Lines
TA22-4WD Agricultural Transmission Modulating Valve
3508B Industrial Engines Switches - Start/Stop
3500B Locomotive Engines Safety Messages
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Injection Actuation Pressure Control Valve - Test
3500 Engines Thermocouple
3500 Engines Thermocouple
3606 and 3608 Engines Cylinder Head - Remove
C280-6 and C280-8 Engines Cylinder Head - Remove
C7 and C9 On-Highway Engines Engine Overspeeds
Generic Installation of the WAVS Cleaning System{7348} Generic Installation of the WAVS Cleaning System{7348}