Water Temperature Regulator
Show/hide table
 | |
| Illustration 1 | g01143443 |
(1) Install the lip type seal into the water temperature regulator housing. Lubricate the sealing lip on the lip type seal with a small amount of antifreeze.
(2) Minimum stroke of the water temperature regulator at fully open temperature ... 9.5 mm (0.4 inch)
(3) Fully open temperature of the water temperature regulator ... 98 °C (208 °F)
Caterpillar Information System:
C7 PETROLEUM Petroleum Engine Fan Drive - Install
C7 and C9 On-Highway Engines Cruise Control Parameters
C15 On-Highway Engine Crankshaft Rear Seal - Install
C15 On-Highway Engine Crankshaft Rear Seal - Remove
C7 and C9 On-Highway Engines Vehicle Speed Parameters
C15 On-Highway Engine Gear Group (Front) - Install
C15 On-Highway Engine Gear Group (Front) - Remove
C15 On-Highway Engine Housing (Front) - Install
C15 On-Highway Engine Housing (Front) - Remove
C7 PETROLEUM Petroleum Engine Fan Drive - Assemble
C4.4 Industrial Engine Fuel Priming Pump
3456 Generator Sets Reference Material
C9 On-highway Engine Turbocharger
C7 PETROLEUM Petroleum Engine Electronic Control Module - Remove and Install
C-10 Petroleum Engine Maintenance Interval Schedule
C-15 Petroleum Engine Maintenance Interval Schedule
3412E Petroleum Engine Maintenance Interval Schedule
3126B Petroleum Engine Maintenance Interval Schedule
C7 and C9 On-Highway Engines Idle Parameters
3500B and 3500C Locomotive Engines Customer Parameters Worksheet
3500B and 3500C Locomotive Engines System Configuration Parameters
3500B and 3500C Locomotive Engines Injector Solenoids
C7 On-Highway Engine Air Compressor - Remove and Install
C7 and C9 On-Highway Engines Dedicated PTO Parameters