Engine Enclosure Group - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-9200 | Lever Puller Hoist | 1 |
B | 138-7574 | Link Bracket | 4 |
- Disconnect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
Show/hide table
Illustration 1 g01223104 - Remove panel (1) from engine enclosure (2).
Show/hide table
Illustration 2 g01223106 - Disconnect harness assembly (3) from the lights. Repeat for the opposite side.
Show/hide table
Illustration 3 g01223109 - Remove bracket assembly (4) from engine enclosure (2). Repeat for the opposite side.
Show/hide table
Illustration 4 g01223110 - Remove bolts (5) from engine enclosure (2).
Show/hide table
Illustration 5 g01223111 - Remove bolts (6) from engine enclosure (2).
Show/hide table
Illustration 6 g01223112 - Remove bolts (7) from the bottom side of frame assembly (8).
Show/hide table
Illustration 7 g01223113 - Disconnect harness assembly (9). Cut and remove the cable straps.
Show/hide table
Illustration 8 g01223114 - Attach Tooling (A) and Tooling (B) onto engine enclosure (2). Attach a suitable lifting device onto Tooling (A) and Tooling (B). The weight of engine enclosure (2) is approximately
680 kg (1500 lb) . Use Tooling (B) in order to level engine enclosure (2). Remove engine enclosure (2).
Caterpillar Information System:
C3.3 Industrial Engine Electrical System
C3.3 Industrial Engine Basic Engine
C3.3 Industrial Engine Cooling System
C3.3 Industrial Engine Lubrication System
The European Union Physical Agents (Vibration) Directive 2002/44/EC Vibration Charts - and Example Calculations
C3.3 Industrial Engine Air Inlet and Exhaust System
C3.3 Industrial Engine Fuel System
C3.3 Industrial Engine General Information
C3.3 Industrial Engine Engine Design
C3.3 Industrial Engine Emissions Certification Film
2005/12/05 New Injection Actuation Pressure (IAP) Sensor Available {1925}
2005/12/01 New Injection Actuation Pressure (IAP) Sensor Available {1925}
CX31 On-Highway Transmission Transmission Hydraulic Control
C3.3 Industrial Engine Fuel Injection Pump Timing - Check
C3.3 Industrial Engine Fuel Injection Pump Timing - Adjust
C3.3 Industrial Engine Fuel System - Prime
C3.3 Industrial Engine Stopping the Engine
C27 and C32 Generator Set Engines Atmospheric Pressure Sensor - Remove and Install
2006/01/02 An Improved Outer Valve Spring is Used {1100, 1108}
C3.3 Industrial Engine Fuel System Pressure - Test
TH48-E80 Petroleum Transmission Oil Filter (Torque Converter)
C3.3 Industrial Engine Refill Capacities and Recommendations
C3.3 Industrial Engine Cold Weather Operation
C27 and C32 Generator Set Engines Coolant Temperature Sensor - Remove and Install