CID 0268 FMI 02 Check Programmable Parameters
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects that one or more of the programmable parameters have not been programmed.
The parameters that have not been programmed are listed on the "Active Diagnostic" screen on the Caterpillar Electronic Technician (ET).
System Response:
The diagnostic code is not logged. Any unprogrammed parameters are set to the default value. Engine performance may be affected. This is dependent on the unprogrammed parameters.
Possible Performance Effect:
Low power
Troubleshooting:
Test Step 1.
Program the parameters. Refer to Troubleshooting, "System Configuration Parameters" for additional information.
Results:
- OK - STOP
Caterpillar Information System:
950G Series II Wheel Loader Hydraulic Principles
D10R Track-Type Tractor Parking
844H Wheel Dozer Lift Cylinder Yoke Bearings - Lubricate
844H Wheel Dozer Circuit Breakers - Reset
D10R Track-Type Tractor Fire Extinguisher Location
D10R Track-Type Tractor Equipment Lowering with Engine Stopped
844H Wheel Dozer Capacities (Refill)
2004/04/05 New Bolts Are Now Used on the Lower Articulation Hitch {7057, 7100, 7117}
D11R Track-Type Tractor Operator Controls
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
D10T Track-Type Tractor Hydraulic System Electrohydraulic Pilot Manifold
545 Wheel Skidder Safety Messages
D5N and D6N Track-Type Tractors AccuGrade Laser Startup (Single Mast System)
844H Wheel Dozer Tilt Cylinder Bearings - Lubricate
SCJ and 8SC Series Alternators Service Tools
906 and 908 Wheel Loaders Hydraulic and Steering System Steering System
SCJ and 8SC Series Alternators Charging System
D10R Track-Type Tractor Emissions Certification Film
AD30 Underground Articulated Truck Output Transfer Gears - Disassemble
CB-214E, CB-224E and CB-225E Vibratory Compactors Machine Systems Hydraulic System Pressure - Release
D5N and D6N Track-Type Tractors AccuGrade Laser Startup (Dual Mast System)
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Machine Systems Bank Valve - Disassemble
2004/03/22 A New Retainer Plate For The Final Drive Bearing And Thrust Washer Improves The Service Life {4050}
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Machine Systems Bank Valve - Assemble