Parking Brake - Remove and Install
拆卸步骤
开始:
- 把驱动轴取下。 请参考拆解和装配, "驱动轴 - 拆卸和安装"。
- 松开停车制动器。 参见 操作和保养手册, "操作员控制装置"。
- 拆下螺栓 (1) 和护圈 (2) 。
Show/hide table
 | |
| 图 1 | g00663592 |
- 拆下制动鼓 (3) 。
Show/hide table
 | |
| 图 2 | g00663600 |
- 卸下螺栓 (5) 。
注: 当您拆下制动器组件 (6) 时，连杆组件 (4) 将掉落。
Show/hide table
 | |
| 图 3 | g00891200 |
- 拆下制动器组件 (6) 。
- 拆下弹簧 (6) 后分离制动器组件 (7) 。
Show/hide table
 | |
| 图 4 | g00891201 |
Show/hide table
 |
弹簧压缩零件如果安装不当，会伤害人体。 为避免伤害，遵照出版的装配程序，并穿上保护装备。 |
安装步骤
- 组装停车制动器 (7) 后安装弹簧 (6) 。
Show/hide table
| | |
| 图 5 | g00891201 |
Show/hide table
|
弹簧压缩零件如果安装不当，会伤害人体。 为避免伤害，遵照出版的装配程序，并穿上保护装备。 |
- 安装连杆组件 (4) 和制动器组件 (6) 。
Show/hide table
| | |
| 图 6 | g00891200 |
- 安装螺栓 (5) 。 将螺栓 (5) 上紧到 120 ± 20 N·m (89 ± 15 lb ft) 的扭矩。
- 安装制动鼓 (3) 。
Show/hide table
| | |
| 图 7 | g00663600 |
- 安装座圈 (2) 和螺栓 (1) 。 将螺栓 (1) 上紧到 120 ± 20 N·m (89 ± 15 lb ft) 的扭矩。
Show/hide table
| | |
| 图 8 | g00663592 |
- 调整停车制动器。 请参阅测试和调整, "停车制动器控制拉线 - 调整"。
End By: 安装驱动轴。 请参考 拆解和装配, "驱动轴 - 拆卸和安装"。
Caterpillar Information System:
Product Link - PL102C System Overview
Replacement of Direct Drive Fan with Rockford Demand Fan{1356, 1359} Replacement of Direct Drive Fan with Rockford Demand Fan{1356, 1359}
963C Track-Type Loader Sound Information and Vibration Information
545 Wheel Skidder Additional Messages
Bench Test Procedure for a 924G, 924GZ, 924H, 924HZ, 928G, 928H, 928HZ, 930G, 930H Wheel Loader and IT28G Integrated Toolcarrier Transmission{3030, 3073, 3139} Bench Test Procedure for a 924G, 924GZ, 924H, 924HZ, 928G, 928H, 928HZ, 930G, 930H Wheel Loader and IT28G Integrated Toolcarrier Transmission{3030, 3073, 3139}
994D Wheel Loader Hydraulic System Bucket Control Pins and Bearings Break-In Procedure - Perform
906 and 908 Wheel Loaders Power Train Parking Brake - Test and Adjust
906 and 908 Wheel Loaders Power Train Brake System Air - Purge
906 and 908 Wheel Loaders Power Train Brake System Air - Purge
545 Wheel Skidder Maintenance Interval Schedule
IT62G Series II Integrated Toolcarrier and 950G Series II and 962G Series II Wheel Loaders Case Drain Screen (Strainer) (Steering Pump, Hydraulic Fan Pump, Motor) - Clean
906 and 908 Wheel Loaders Power Train Service Brake - Test and Adjust
844H Wheel Dozer Monitoring System
2004/03/22 Special Instruction, REHS1837 , "Bench Test Procedure for Bosch Rexroth A6VM HD Motors" Is Now Available {5058}
3406E, C-10, C-12, C-15, C-16 Truck Engines Product Storage
2006/01/02 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
D10R Track-Type Tractor Cab Air Filter (Pressurized Assembly) - Replace
906 and 908 Wheel Loaders Hydraulic and Steering System Steering System
C15 and C18 Engines for Caterpillar Built Machines Fan Drive
844H Wheel Dozer Equipment Lowering with Engine Stopped
545 Wheel Skidder Safety Messages
D10T Track-Type Tractor Hydraulic System Electrohydraulic Pilot Manifold
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
D11R Track-Type Tractor Operator Controls