C27 and C32 Engines for Caterpillar Built Machines Caterpillar


CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt

Usage:

854K 221
Kondisi-kondisi yang mendorong penciptaan kode ini:

Modul Kontrol Elektronik (ECM, Electronic Control Module) mendeteksi tegangan di atas normal pada suplai 5 volt.

Tanggapan:

Kode tercatat. Lampu periksa engine akan menyala saat kode diagnostik ini aktif. ECM menetapkan semua sensor tekanan ke nilai default.

Kemungkinan Akibat Perlaksanaan:

  • Daya engine turun.

Pemecahan Masalah:

Langkah Pengujian" status="1 1. Laksanakan, Prosedur Pemeriksaan berikut: "Sirkuit Suplai Sensor Tekanan Engine 5 Volt - Pengujian"

Hasil:

  • OK - BERHENTI

Caterpillar Information System:

C27 and C32 Engines for Caterpillar Built Machines CID 0172 FMI 04 Intake Manifold Air Temp short to ground
C27 and C32 Engines for Caterpillar Built Machines CID 0172 FMI 03 Intake Manifold Air Temp open/short to +batt
C27 and C32 Engines for Caterpillar Built Machines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
D8T Track-Type Tractor Fuel System - Prime
D8T Track-Type Tractor Final Drive Oil Level - Check
D8T Track-Type Tractor Final Drive Oil - Change
2003/09/01 Correction to Testing and Adjusting , "Margin Pressure Adjustment Procedure" {4306, 5070, 5086}
D8T Track-Type Tractor Ether Starting Aid Cylinder - Replace
994D Wheel Loader Cooling System Coolant Level - Check
C11 and C15 Engines for Caterpillar Built Machines CID 0102 FMI 04 Boost Pressure Sensor short to ground
D8T Track-Type Tractor Fuses and Circuit Breakers - Replace/Reset
994D Wheel Loader Welding on Machines and Engines with Electronic Controls
C27 and C32 Engines for Caterpillar Built Machines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
C11 and C15 Engines for Caterpillar Built Machines CID 0190 FMI 08 Engine Speed signal abnormal
C15 and C18 Engines for Caterpillar Built Machines CID 1834 FMI 02 Ignition Key Switch loss of signal
C27 and C32 Engines for Caterpillar Built Machines CID 0261 FMI 13 Engine Timing Calibration required
D8T Track-Type Tractor Lift Cylinder Yoke Bearings - Lubricate
D8T Track-Type Tractor Pivot Shaft Oil Level - Check
587R Pipelayer Radiator Pressure Cap - Clean/Replace
2014/07/30 New Cylinder Head Groups and Valve Mechanisms {1100, 1102, 1121, 1123}
2003/12/01 New Cylinder Head Groups and Valve Mechanisms {1100, 1102, 1121, 1123}
D8R and D8T Track-Type Tractors Recoil Spring Compartment Oil Level - Check
C15 and C18 Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
D8T Track-Type Tractor Power Train System Oil Sample - Obtain
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.