CID 0253 FMI 02
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects incorrect engine software.
System Response:
If equipped, the warning light will come on.
This diagnostic code is not logged.
Factory passwords are required to clear this diagnostic code.
The engine will not start.
The flash file in the ECM is from the wrong engine family.
Use the electronic service tool to install the correct flash file into the ECM. Refer to the Troubleshooting Guide, "Flash Programming".
Test Step 1. Perform the following diagnostic procedure: None
Results:
- OK - STOP
Caterpillar Information System:
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0190 FMI 08
C6.6 Industrial Engine Engine Oil Filter Base
C6.6 Generator Set CID 0006 FMI 06
C6.6 Generator Set CID 0005 FMI 06
C4.4 Generator Set Engines CID 0004 FMI 06
C4.4 Generator Set Engines CID 0003 FMI 06
C4.4 Generator Set Engines CID 0002 FMI 06
C4.4 Generator Set Engines CID 0001 FMI 06
C6.6 Generator Set CID 0006 FMI 05
C6.6 Generator Set CID 0005 FMI 05
C4.4 Generator Set Engines CID 0004 FMI 05
C4.4 Generator Set Engines CID 0003 FMI 05
C4.4 and C6.6 Engines for Caterpillar Built Machines CID 0268 FMI 02
C4.4 and C6.6 Engines for Caterpillar Built Machines CID 0342 FMI 08
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0261 FMI 11
2005/08/01 Correct Timing Procedure for the Engine {1206, 1212}
3412E, C30 and C32 Marine Engines Heat Exchanger - Disassemble - Without Fuel Cooler
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Engine Oil Cooler - Remove and Install - In Chassis
C-12 Generator Set Engine Excessive White Smoke
C27 and C32 Generator Sets Safety Messages
3126B Generator Set Engine Intermittent Engine Shutdown
3126B Generator Set Engine Intermittent Low Power or Power Cutout
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0590 - FMI 09
3126B Generator Set Engine Low Power/Poor or No Response to Throttle