Illustration 1 | g00425319 |
(1) Torque for the eight bolts ... 1800 ± 200 N·m (1320 ± 150 lb ft)
Illustration 2 | g00425320 |
(2) Torque for the gauge assembly ... 45 ± 6 N·m (33 ± 4 lb ft)
(3) Torque for the two air purge screws ... 11 ± 4 N·m (8 ± 3 lb ft)
(4) Torque for the pressure relief fitting ... 13 ± 4 N·m (10 ± 3 lb ft)
(5) Torque for the plug ... 45 ± 6 N·m (33 ± 4 lb ft)
(6) At assembly, rubber toric seals must be clean and dry and all surfaces that contact rubber toric seals must be clean and dry. Immediately before installation, apply a thin layer of oil on the surfaces of the metal seals that contact the rubber toric seals. The seal must be assembled square with the bore. Rubber toric seals must not have bulged and these seals must also not have twisted.
(7) Torque for the twenty-four bolts (each side) ... 300 ± 40 N·m (220 ± 30 lb ft)
(8) Torque for the ten bolts ... 300 ± 40 N·m (220 ± 30 lb ft)
(9) Apply 1U-8846 Liquid Gasket to the contacting surfaces prior to assembly.
Illustration 3 | g00887173 |
Left Side View |
(10) Drain plug for 143-5257 Fixed Axle Housing
- Torque for the drain assembly ... 130 ± 10 N·m (96 ± 7 lb ft)
- Torque for the plug ... 65 ± 6 N·m (48 ± 4.5 lb ft)
Note: Use a 3/4 inch pipe in order to activate the valve for draining.
Illustration 4 | g00887174 |
Section A-A and Detail B |
(11) Apply 1U-8846 Liquid Gasket to the contacting surfaces prior to assembly.
(12) Torque for the six bolts ... 55 ± 10 N·m (40 ± 7 lb ft)