 | |
| Illustration 1 | g01357590 |
(1) Torque for the bolts that hold the cam and lever to the shaft ... 48 ± 4 N·m (35 ± 3 lb ft)
(2) Torque for 20 bolts ... 30 ± 4 N·m (22 ± 3 lb ft)
(3) When the cam is in the NEUTRAL position, adjust the spools even with surface (A) .
(4) Torque for the four bolts that hold the hydraulic controls to the clutch housings ... 48 ± 4 N·m (35 ± 3 lb ft)
 | |
| Illustration 2 | g01357593 |
(5) Torque for three nuts ... 34 ± 7 N·m (25 ± 5 lb ft)
(6) Torque for the four bolts that hold the switch cover to the transmission case ... 48 ± 4 N·m (35 ± 3 lb ft)
(7) Lightly lubricate the sealing lip with the lubricant that is being sealed. Before you install the lip seal, coat the seal bore with 9U-5839 Liquid Gasket and permit the gasket material dry. Do not apply the gasket material to the lip seal case.
(8) 2S-1381 Spring
- Length under test force ... 75.4 mm (2.97 inch)
- Test force ... 180 ± 13 N (40 ± 3 lb)
- Free length after test ... 58.0 mm (2.30 inch)
- Outside diameter ... 15.8750 mm (0.625 inch)
- Pin diameter for the hook ... 9.53 mm (0.375 inch)
- Pin groove diameter ... 6.35 mm (0.250 inch)
- Test force ... 180 ± 13 N (40 ± 3 lb)