D6R Track-Type Tractor Caterpillar


Starting Above 0°C (32°F)

Usage:

D6R 2HM



Illustration 1g00100348

  1. Move the transmission directional control lever to the NEUTRAL position.



    Illustration 2g00100349

  1. Use the engine start switch key (1) in order to unlock the parking brake. The parking brake switch (2) must be ENGAGED .



    Illustration 3g00103647

  1. Move the implement control levers to the HOLD position.



    Illustration 4g00103644

  1. Turn the battery disconnect switch to the ON position. The battery disconnect switch is inside of the access door on the left side of the machine.

  1. Return the governor control lever to the LOW IDLE position.



    Illustration 5g00103641

  1. Turn the key start switch to the ON position. The system performs an automatic self-test. When you turn on the start switch key the test is performed. If the test is complete without any faults, proceed to next step. If the system detects a fault, check the electrical system. Make all of the necessary repairs before you start the engine.



    Illustration 6g00103642

  1. The engine oil pressure light should turn on, and the alternator light should turn on.



    Illustration 7g00103643

  1. Turn the start switch key to the START position. Crank the engine. Release the key when the engine starts.


NOTICE

Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result if the engine rpm is not kept low until the oil gauge display verifies that the oil pressure is sufficient.


Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.