Engine Crankcase Breather - Clean
Show/hide table
NOTICE |
---|
Perform this maintenance with the engine stopped. |
If the crankcase breather is not maintained on a regular basis, the crankcase breather will become plugged. A plugged crankcase breather will cause excessive crankcase pressure that may cause crankshaft seal leakage.
Show/hide table
Illustration 1 | g01062530 |
Typical example (1) Hose clamp (2) Breather assembly (3) Retaining clamp |
- Loosen the hose clamp (1) and remove the hose from breather assembly (2).
- Loosen the retaining clamp (3). Remove breather assembly (2) and the seal.
- Wash the breather element in solvent that is clean and nonflammable. Allow the breather element to dry before installation.
- Install a breather element that is clean and dry. Install breather assembly and seal (2) and install clamp (3). Refer to the Specifications, SENR3130 in order to locate the proper torques.
- Install the hose. Install the hose clamp (1). Refer to the Specifications, SENR3130 in order to locate the proper torques.
Caterpillar Information System:
C7 Marine Engine Engine Design
3406E, C-10 and C-12 On-highway Engines 0253-11 Check Transmission Customer Parameters (56)
3406E, C-10 and C-12 On-highway Engines 0232-04 5 Volt Supply voltage low (21)
3508B, 3512B, and 3516B High Displacement Generator Sets Product Storage
3406E, C-10 and C-12 On-highway Engines 0232-03 5 Volt Supply voltage high (21)
SCJ and 8SC Series Alternators Regulator - Test
C7 Marine Engine Fuel System
3512B and 3516B High Displacement Locomotive Engines Product Lifting
SCJ and 8SC Series Alternators Diode Assembly - Test
3406E, C-10 and C-12 On-highway Engines 0244-02 Event Recorder Data Lost (02)
C15 and C18 Engines for Caterpillar Built Machines Vibration Damper - Check
C7 Marine Engine Engine Oil Pressure - Test
C7 and C9 On-Highway Engines Timer Parameters
3406E, C-10 and C-12 On-highway Engines 0254-12 ECM Fault (53)
SCJ and 8SC Series Alternators Residual Magnetism - Restore
SCJ and 8SC Series Alternators Brush Assembly - Test
SCJ and 8SC Series Alternators Brush Length - Check
C11 and C13 Engines Cylinder Head Valves
C-10 Petroleum Engine Engine Oil Level - Check
3406E and 3456 Generator Set Engines System Configuration Parameters
C7 Marine Engine Turbocharger - Inspect
3406E and 3456 Generator Set Engines Engine Will Not Crank
3500B Locomotive Engines Engine Mounts - Check
C7 Marine Engine Crankcase Breather