Speed Sensor (Engine) - Adjust
Show/hide table
Illustration 1 | g00289497 |
Speed Sensor (1) Speed sensor (2) Locknut (A) Air gap |
Note: The engine speed sensor is commonly referred as a magnetic pickup sensor.
This adjustment procedure is for the engine speed sensor.
- Remove the speed sensor (1) from the flywheel housing. Remove all debris from the tip of the speed sensor. Align a ring gear tooth directly in the center of the threaded sensor opening.
- By hand, screw the speed sensor (1) into the hole until the end of the sensor contacts the gear tooth.
- Turn the sensor (1) in the counterclockwise direction through 270 degrees (three-fourths turn).
- Tighten locknut (2) to
25 ± 5 N·m (18 ± 4 lb ft) .Note: Do not allow speed sensor (1) to turn as locknut (2) is tightened.
Caterpillar Information System:
EMCP3 External Potential Transformer Connections
EMCP3 Typical Generator Abbreviations
EMCP3 Electrical Connector - Inspect
3408C, 3412C and 3412D High Performance Marine Engines Cooling System
EMCP3 Real Time Clock Programming
2003/11/01 New Seal for the Front Housing {1151}
2003/11/01 New Oil Pan and Integral Seal {1302, 1302, 1302}
3508, 3512, and 3516 Generator Sets Cooling System Coolant Sample (Level 2) - Obtain
3508, 3512, and 3516 Generator Sets Cooling System Coolant Sample (Level 1) - Obtain
C9 Marine Engines and C9 Marine Generator Sets Valve Mechanism Cover - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Front Cover - Install
C9 Marine Engines and C9 Marine Generator Sets Front Cover - Remove
EMCP3 Electronic Control Module (Generator Set) - Replace
3408C, 3412C and 3412D High Performance Marine Engines Engine Valve Lash - Inspect/Adjust
3408C, 3412C and 3412D High Performance Marine Engines Compression - Test
3408C, 3412C and 3412D High Performance Marine Engines Exhaust Temperature - Test
3408C, 3412C and 3412D High Performance Marine Engines Turbocharger - Inspect
3408C, 3412C and 3412D High Performance Marine Engines Inlet Manifold Pressure - Test
3408C, 3412C and 3412D High Performance Marine Engines Air Inlet and Exhaust System - Inspect
3408C, 3412C and 3412D High Performance Marine Engines Finding Top Center Position for No. 1 Piston
3408C, 3412C and 3412D High Performance Marine Engines Governor - Adjust
3408C, 3412C and 3412D High Performance Marine Engines Engine Speed - Check
3408C, 3412C and 3412D High Performance Marine Engines Fuel Ratio Control - Adjust
3408C, 3412C and 3412D High Performance Marine Engines Fuel Setting - Adjust