Usage:
START BY:
a. remove fuel injection pump housing and governor (interim scroll fuel system)
1. Remove fuel block (1) from the fuel injection pump housing.
2. Remove bolts (2), and remove fuel pump drive (3) from the fuel injection pump housing.
Install Fuel Pump Drive (Interim Scroll Fuel System)
1. Install the gasket on the fuel pump drive.
NOTE: Groove (slot) (2) in the camshaft of the fuel injection pump is not in the center of the shaft so shaft (1) in the fuel pump drive must be turned to the same position when the pump drive is installed.
2. Install the fuel pump drive on the fuel injection pump housing, and install the bolts that hold it in place.
3. Be sure the O-ring seal is in position on fuel block (3), and put clean oil on the O-ring seal. Install the fuel block in the end of the fuel injection pump housing as shown.
END BY:
a. install fuel injection pump housing and governor (interim scroll fuel system)
Disassemble Fuel Pump Drive (Interim Scroll Fuel System)
START BY:
a. remove fuel pump drive (interim scroll fuel system)
1. Remove fuel transfer pump (1).
2. Use tool (A) to remove snap ring (2). Remove O-ring seal (3).
3. Remove shaft assembly (4) from the housing.
4. Remove shaft (6) from cam (5) with tool (B) and a press.
5. Remove bearing (7) from cam (5).
Assemble Fuel Pump Drive (Interim Scroll Fuel System)
1. Install bearing (1) on cam (2).
2. Install shaft (3) in cam (2) with a press.
3. Put shaft assembly (4) in position in housing (5).
4. Install O-ring seal (7).
5. Use tool (A) to install snap ring (6).
6. Be sure the O-ring seal is in position on fuel transfer pump (8), and put clean oil on the O-ring seal.
7. Put fuel transfer pump (8) in position on the fuel pump drive, and install the three nuts that hold it in place.
END BY:
a. install fuel pump drive (interim scroll fuel system)