Engine Crankcase Breather - Clean/Replace
Show/hide table
 |
发电机组运转产生的高压可能造成严重的人身伤亡。 在进行任何保养或修理之前，确保发电机不能起动。 将发动机操控开关置于"关闭(OFF)"位置。 将"不准操作"标签系到所有启动操作装置上。 断开蓄电池或使起动系统不能被起动。 锁定所有开关设备和与发电机相连的自动转换开关。 |
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
| 注意 |
|---|
在检验、保养、测试、调整及维修产品时，务必留心，确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前，要准备好用合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上液体的工具及用品，参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。 按照当地法规和指令处置所有液体。 |
- 松开螺栓 (2) ，并且从气门机构盖上拆下呼吸器盖 (1) 。 清洁呼吸器盖 (1) 内的排气孔 (3) 。
Show/hide table
 | |
| 图 1 | g00955947 |
典型示例 (1) 呼吸器盖 (2) 呼吸器盖螺栓 (3) 呼吸器盖内的排气孔 (4) 弹簧 (5) 膜片和板 (6) 腔室 (7) 排气孔 | |
- 拆下弹簧 (4) 。 拆下膜片和板 (5) 。
- 清洁排气孔 (7) 。 清洁气门机构盖内呼吸器组件的腔室 (6) 。
- 为呼吸器组件安装新的膜片和板 (4) 。 安装新弹簧 (3) 。 将呼吸器组件装入气门机构盖的腔室 (5) 中。
Show/hide table
| 注意 |
|---|
确保呼吸器总成零部件正确安装。如果呼吸器总成不能正常工作，发动机可能发生损坏。 |
- 安装呼吸器盖 (1) 和四条螺栓 (2) 。 拧紧螺栓。
Caterpillar Information System:
3054E Industrial Engine Exhaust Manifold - Remove and Install
C11 and C13 Industrial Engines Cylinder Block
C-15 Petroleum Engine Auxiliary Water Pump - Remove
C13 Engine for Combat and Tactical Vehicles Engine Oil Pan
C11 and C13 Petroleum Engines Engine Oil Pan
C11 and C13 Industrial Engines Engine Oil Pan
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Vibration Troubleshooting
3054E Industrial Engine Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel System - Prime
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel Injection Timing - Check
C1.5 and C2.2 Generator Sets Additional Messages
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Electrical System
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Clutch Pedal Position Switch Circuit - Test
C-15 Petroleum Engine Auxiliary Water Pump - Install
C7 and C9 On-Highway Engines 0168-00 Excessive ECM Battery Power (17)
3054E Industrial Engine Cylinder Head - Remove
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Serial Number Plate
C1.5 and C2.2 Generator Sets Generator Set Installation
C15 and C18 Petroleum Generator Sets Engine - Clean
G3520B Engines Jacket Water to Engine Oil Differential Temperature (Low)
3054E Industrial Engine Cylinder Head - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Cruise Control Switch Circuit - Test
Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and Series 3600 Gas Applications{1926} Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and Series 3600 Gas Applications{1926}
3126B and 3126E On-highway Engines 0022-11 Primary to Secondary Engine Speed Signal Calibration (42)