C9 Marine Engines and C9 Marine Generator Sets Caterpillar


Engine Oil Filter Base

Usage:

C9 C9B



Illustration 1g01384144

Right side view

(1) Torque for bolts ... 30 ± 7 N·m (22 ± 5 lb ft)




Illustration 2g01386502

(2) Oil filter base

Apply 154-9731 Thread Lock Compound on the tapered end of the hollow stud to length (B) . ... 10.0 ± 1.5 mm (0.39 ± 0.06 inch)
Torque for hollow stud (3) ... 68 ± 7 N·m (50 ± 5 lb ft)

  1. Tighten the bolts to the standard torque in the numerical sequence that is shown in Illustration 1.

  1. Again tighten the bolts to the standard torque in the numerical sequence.



Illustration 3g01384157

Front view




Illustration 4g01386679

(4) Oil filter base

Apply 154-9731 Thread Lock Compound on the tapered end of the hollow stud to length (D) . ... 10.0 mm (0.40 inch)
Torque for hollow stud (7) ... 80 ± 15 N·m (60 ± 11 lb ft)

(5) Put clean engine oil on the seal. Tighten the filter until the seal contacts the base. After the seal contacts the base, rotate the filter by 270 degrees.

(6) Tighten the cover to the following torque. ... 70 ± 10 N·m (50 ± 7 lb ft)




Illustration 5g01384164

Top view

(8) 242-3864 Spring

Length under test force ... 43.18 mm (1.700 inch)
Test force ... 43.7 N (9.8 lb)
Free length after test ... 58.50 ± 0.50 mm (2.303 ± 0.020 inch)
Outside diameter ... 11 mm (0.4 inch)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.