Voltage Adjustment Range - Calibrate
Show/hide table
Illustration 1 | g00899851 |
K65-12B Voltage Regulator (1) Factory calibration adjustment (2) Voltage adjustment |
Show/hide table
Illustration 2 | g01021519 |
Show/hide table
The Cat K65-12B Voltage Regulator presents an electrical shock/electrocution hazard. This hazard will cause serious injury or death. Service by trained personnel only. The terminals and heat sinks are live at hazardous voltages when power is applied and for up to 8 minutes after power is removed. |
Show/hide table
NOTICE |
---|
Do not operate generator at a voltage greater than 5% above the name plate rating. |
The factory calibration adjustment (1) should be used by the factory technicians only. The following procedure can be used if the factory calibration has been disturbed:
- Remove the seal from the factory calibration adjustment (1) .
- Start the genset.
- Run the genset at no load.
- Turn the factory calibration adjustment (1) in a fully counterclockwise direction.
- Turn the voltage adjust rheostat (2) in a fully clockwise direction.
- Slowly turn the factory calibration adjustment (1) CW until the voltage on 20-22-24 is 144 ± 1 ACV.
- Turn the voltage adjust rheostat (2) CCW.
- Verify that the voltage on 20-22-24 is less than 90 ACV. The unit is calibrated.
- Seal the factory calibration adjustment (1) .
Caterpillar Information System:
G3500B Engines Humidity Sensor - Inlet Air
K65-12B Voltage Regulator Knee Frequency - Adjust
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0441 - FMI 12 (for MUI Engines)
K65-12B Voltage Regulator Unstable Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0334 - FMI 04 (for EUI Engines)
3412E, C30 and C32 Marine Engines Switch Circuits - Test
3412E, C30 and C32 Marine Engines Unit Injector Hydraulic Pump - Install
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0269 - FMI 03
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0190 - FMI 03
K65-12B Voltage Regulator High Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0190 - FMI 02
K65-12B Voltage Regulator Low Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for MUI Engines)
K65-12B Voltage Regulator Voltage Regulator - Test
G3600 Engines Pressure Switch - Electrohydraulic
3056E Industrial Engine Vibration Damper and Pulley
K65-12B Voltage Regulator Wiring Diagrams
G3500B Engines Inlet Air Temperature Sensor
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Temperature Sensor
G3500B Engines Jacket Water Temperature Sensor
G3500B Engines Atmospheric Pressure Sensor
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for EUI Engines)
K65-12B Voltage Regulator Cross Current Compensation
C9 Engine For Caterpillar Built Machines Camshaft Bearings - Remove