794 AC Off-Highway Truck Caterpillar


Air Conditioner Filter - Clean

Usage:

794 AC HRT
If a reduction in air circulation is noticed, clean the radial seal air filter for the air conditioner.

The air filter element for the air conditioner is located behind the access door on the left rear of the cab.

  1. Prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".


    Illustration 1g03419733

  2. Remove bolts and air vent. Remove air filter element (1).

  3. Visually inspect the air filter element before cleaning. Inspect the air filter element for damage to the seal, the pleats, and the outer cover. Replace a damaged air filter element with a new air filter element.

  4. Use low pressure compressed air in order to remove the dust from the dirty air filter element. Air pressure must not exceed 207 kPa (30 psi). Direct the air flow up the pleats and down the pleats from the inside of the filter element. Take extreme care in order to avoid damage to the pleats.

  5. Install the clean air filter element, install vent, and tighten bolts.

Caterpillar Information System:

2013/08/23 Low Engine Oil Pressure Issues, Oil Pump Failures for C9 and C9.3 Machine Engines {1304, 1315}
Product LinkTM PL421 Installation Quick Reference Guide{7606} Product LinkTM PL421 Installation Quick Reference Guide{7606}
336F XE Excavator Machine System Swing Bearing Movement - Measure
Air Conditioning and Heating R134a for All Caterpillar Machines Automatic Temperature Control System (ECM Controlled) Troubleshooting
Air Conditioning and Heating R134a for All Caterpillar Machines Automatic Temperature Control Panel Troubleshooting - 584 and 584HD Forwarders
M316C Excavator Machine System Stick Cylinder Lines
M316C Excavator Machine System Stick Cylinder Lines
M316C Excavator Machine System Boom Cylinder Lines
M316C Excavator Machine System Muffler
R1600H Load Haul Dump Power Train Speed Sensor (Torque Converter Output)
349F and 352F Excavators Engine Supplement Flame Detection Temperature Sensor - Remove and Install
326F, 329F and 330F Excavators Machine Systems Counterbalance Valve (Travel) - Assemble
M316C Excavator Machine System Hydraulic Tank and Filter
M316C Excavator Machine System Hydraulic Fan Drive Lines
M316C Excavator Machine System Pilot Lines
M316C Excavator Machine System Pilot Lines
Procedure to Rework the Ground Harness for the Display Panel and Fuel Sender for 307E Mini Hydraulic Excavators{1408} Procedure to Rework the Ground Harness for the Display Panel and Fuel Sender for 307E Mini Hydraulic Excavators{1408}
2013/08/19 New Software Is Now Available For All Cat® Products With PL522 China System {7606, 7620}
PM620 and PM622 Cold Planer Slope Operation
Steering Column Difficult or Unable to Adjust on Certain M300D Wheeled Excavators{4310} Steering Column Difficult or Unable to Adjust on Certain M300D Wheeled Excavators{4310}
349F and 352F Excavators Window Wiper Delay - Test
349F and 352F Excavators Switch Circuits - Test
794 AC Off-Highway Truck Automatic Lubrication Reservoir - Fill
Installation of the 390-1561 Front Lines Gp on Certain Excavators{5057} Installation of the 390-1561 Front Lines Gp on Certain Excavators{5057}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.