Engine Oil Cooler - Remove
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal.
Show/hide table
Illustration 1 g00761767 - Disconnect electrical harness (1).
- Remove the bolts in elbow (2) and tube (3). Remove the unit from the engine oil cooler bonnet.
Show/hide table
Illustration 2 g00761811 - Remove the bolts from elbow assembly (4). Remove the bolts from flange (5).
Show/hide table
Illustration 3 g00761851 - Remove two bolts (7) from tube assembly (6).
Show/hide table
Illustration 4 g00762168 - Attach a suitable lifting device to the engine oil cooler (8).
Show/hide table
Illustration 5 g00762200 - Remove two bolts (9).
Show/hide table
Illustration 6 g00762213 - Remove two bolts (10).
- Remove engine oil cooler (8) with elbow assembly (4) and remove tube assembly (6). The weight of the engine oil cooler is approximately
78 kg (171 lb) .
Caterpillar Information System:
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Injector Solenoids
3126B Industrial Engine Turbocharger - Install
C4.4 Industrial Engine Fuel Conservation Practices
3126B Industrial Engine Vibration Damper
3054 Engine Engine Oil Pump - Inspect
3126B Industrial Engine Water Pump - Install
3126B Industrial Engine Engine Oil Pressure Sensor - Test
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Speed/Timing Sensor
3054 Engine Cylinder Head - Inspect
C32 Petroleum Engines Diagnostic Flash Code Retrieval
3054, 3054B and 3056 Marine Engines Engine Valve Lash - Inspect/Adjust
3126B Industrial Engine Water Pump - Assemble
C-15 and C-16 Industrial Engines Sensors and Electrical Components
3054 Engine Engine Oil Pressure - Test
2000/12/01 Recommended Procedure For Lubricating And Tightening The Bolts That Fasten The Counterweights To The Crankshaft {1231}
3054 and 3056 Marine Generator Set Engines Cooling System - Check - Overheating
3126B Industrial Engine Turbocharger - Remove
3054 and 3056 Marine Generator Set Engines Cooling System - Inspect
3054 and 3056 Marine Generator Set Engines Cooling System - Test
3054 Engine Cylinder Liner Projection - Inspect
C-15 and C-16 Industrial Engines Reference Material
3126B Engines Basic Engine
322C Excavator Machine System Specifications Track
3054 and 3056 Marine Generator Set Engines Cylinder Liner - Remove