NOTICE |
---|
Never transport the machine with the engine running. |
Comply with any laws that govern the characteristics of a load (length, width, height, and weight).
- Move the hydraulic lockout control to the LOCKED position.
Illustration 1 | g00543871 |
- Turn the engine start switch to the OFF position in order to stop the engine. Remove the engine start switch key.
- Turn the battery disconnect switch to OFF and remove the disconnect switch key.
- Remove the ether starting aid cylinder (if equipped).
ReferenceRefer to Operation and Maintenance Manual, "Ether Starting Aid Cylinder - Replace" for the removal procedure.
- Lock the door and the access covers. Attach any vandalism protection.
- The Product Link antenna may be relocated in order to meet the regulations regarding height of some locations. The Product Link antenna is located on top of the cab. Perform the following procedure in order to move the Product Link antenna to the transport position.
- Remove the hand rails from the machine.
Show/hide tableIllustration 2 g01440190
- Loosen the bolt (4) and screw (5) .
Show/hide tableIllustration 3 g01440517
- Remove the bracket (6) with the antenna (2) from the top of the cab.
- Locate the bracket (6) with antenna (2) on the top cover of the cooling package.
Show/hide tableIllustration 4 g01440182
- Secure the bracket (6), and tighten with the bolt (4) and screw (5) .
- Return the antenna to the operating position before operating the machine.
- Cover the exhaust opening.
- Chock the tracks and secure the machine with tie-downs. Make sure that you use the proper rated wire cable.
Use the front towing eyes on the lower frame, the rear towing eyes on the lower frame, and the rear towing eye that is on the upper frame.
Securely fasten all loose parts and all removed parts to the trailer or to the rail car.
NOTICE |
---|
Do not allow the turbocharger to rotate while the engine is not operating. Damage to the turbocharger can result. |
Note: Before you remove the excavator from the transport machine, remove the protective covering from the exhaust opening.
Illustration 5 | g00584633 |
Typical example |
When the engine is stopped, the swing parking brake is automatically applied. This prevents the upper structure from swinging.
NOTICE |
---|
In freezing weather, protect the cooling system with antifreeze, to the lowest outside expected temperature on the travel route. Or, drain the cooling system completely. |