Flywheel Housing
Usage:
Tighten flywheel housing bolts in number sequence to a torque of ... 105 ± 20 N·m (75 ± 15 lb ft)
(A) Timing bolt hole.
NOTE: Refer to Flywheel Housing Runout And Flywheel Housing Bore in Systems Operation, Testing & Adjusting for the correct methods of flywheel housing inspection.
NOTE: Front face of flywheel housing and rear face of block must be free of oil, dirt, water, assembly compounds and other contaminants during assembly. With an authorized applicator, apply a continuous film of 1U8846 Gasket Maker to entire joint surface. Assembly of flywheel housing to the cylinder block must be completed within 20 minutes of sealant application.
Caterpillar Information System:
3306B GENERATOR SET ENGINE Flywheel
3306B GENERATOR SET ENGINE Engine Front Support
3306B GENERATOR SET ENGINE Crankshaft Pulley
3306B GENERATOR SET ENGINE Connecting Rod and Main Bearing Journals
3306B GENERATOR SET ENGINE Bearing Surface (Journal) For Connecting Rods
3306B GENERATOR SET ENGINE Bearing Surface (Journal) For Main Bearings
3306B GENERATOR SET ENGINE Crankshaft
3306B GENERATOR SET ENGINE Pistons And Rings
3306B GENERATOR SET ENGINE Connecting Rod
3306B GENERATOR SET ENGINE Cylinder Liner Projection
3306B GENERATOR SET ENGINE Cylinder Liners
3306B GENERATOR SET ENGINE Camshaft Bearings
3306B GENERATOR SET ENGINE Alternator And Regulator
3306B GENERATOR SET ENGINE Electric Starting Motor
3306B GENERATOR SET ENGINE Tachometer Calibration Chart
3306B GENERATOR SET ENGINE Digital Tachometer
3306B GENERATOR SET ENGINE Sensors
3306B GENERATOR SET ENGINE Sending Units
3306B GENERATOR SET ENGINE Switches
3306B GENERATOR SET ENGINE Shutoff Solenoid Energized To Run
3306B GENERATOR SET ENGINE Magnetic Pickup
3306B GENERATOR SET ENGINE Jacket Water Heater
3306B GENERATOR SET ENGINE Ether Atomizer Assembly
3306B GENERATOR SET ENGINE Ether Start Valve Assembly