Removal Procedure
Start By:
- Remove the engine oil level gauge. Refer to Disassembly and Assembly, "Engine Oil Level Gauge (Dipstick) - Remove and Install".
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (1). Loosen bolts (2) and remove panel (3) from below the engine.
Illustration 1 | g00983802 |
- Drain the engine oil into a suitable container for storage or for disposal. The capacity of the engine crankcase and filter is approximately 17.5 L (4.62 US gal).
- Cut and remove cable strap (4). Remove bolts (5) and remove oil pan (6). Remove the gasket.
Illustration 2 | g00983820 |
Installation Procedure
- Clean the mating surfaces of both the oil pan and the engine. Install a new gasket. Position oil pan (6) and install bolts (5). Install a new cable strap (4) .
Illustration 3 | g00983820 |
- Position panel (3) below the engine. Tighten bolts (2). Install bolts (1) .
Illustration 4 | g00983802 |
- Fill the engine with oil. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check". Refer to Operation and Maintenance Manual, "Lubricants Viscosities and Refill Capacities".
End By: Install the engine oil level gauge. Refer to Disassembly and Assembly, "Engine Oil Level Gauge (Dipstick) - Remove and Install".