Fuel Transfer Pump - Install - If Equipped
安装步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 清理所有部件和配合面。 检查所有部件。 如果部件磨损或损坏，则用新件更换。
- 利用 1U-6396 O 形圈组件附着剂 润滑 O 形密封圈后将 O 形密封圈安装到单体喷油器液压泵上。
- 将燃油输送泵 (4) 定位到单体喷油器液压泵上后安装两条螺栓 (3) 。
Show/hide table
 | |
| 图 1 | g00644483 |
- 拆下燃油出口 (2) 和燃油进口 (1) 上的螺塞。
- 安装燃油出口管和燃油进口管。
Caterpillar Information System:
315C Excavator Hydraulic System Swing Drive
5110B Excavator Machine Systems Swivel - Disassemble
315C Excavator Hydraulic System Check Valve (Return Makeup) - Slow Return Check Valve
3126B Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove - If Equipped
315C Excavator Hydraulic System Hydraulic Oil Cooler
315C Excavator Hydraulic System Travel Hydraulic System
315C Excavator Hydraulic System Cylinders (Boom, Stick and Bucket)
315C Excavator Hydraulic System Solenoid Valve (Proportional Reducing)
315C Excavator Hydraulic System Solenoid Valve (Hydraulic Activation)
315C Excavator Hydraulic System Gear Pump (Pilot)
315C Excavator Hydraulic System Main Hydraulic System
315C Excavator Hydraulic System Pilot Hydraulic System
315C Excavator Hydraulic System Return Hydraulic System
BP22 and BP25 Pick-Up Brooms Gerotor Motor (Broom)
Installation of the Blank Hooks{6001, 6129} Installation of the Blank Hooks{6001, 6129}
BA22, BA25 and BA30 Angling Brooms Brooms - BA30
365B and 365B Series II Excavators Hydraulic System Fan Motor Speed (Hydraulic and Radiator Cooling) - Test and Adjust
5110B Excavator Machine Systems Track Tension Cylinder - Install
311C Excavator Machine System Specifications Stick - 2250 mm (7 ft 5 inch)
311C U Excavator Hydraulic System General Information
BA22, BA25 and BA30 Angling Brooms Brooms - BA22
BA22, BA25 and BA30 Angling Brooms Brooms - BA25
Product Identification Numbers (PIN) Location Guide Excavator (Track)
5110B Excavator Machine Systems Swivel - Assemble