Engine Oil Cooler - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Before assembly, check the condition of the gaskets and the O-ring seals. If the gaskets or the O-ring seals are worn or damaged, use new parts for replacement.
- Put O-ring seals (6) in position on adapter (5). Put clean engine oil on the O-ring seals. Install adapter (5) in elbow (3).
Show/hide table
Illustration 2 g00619616 - Put O-ring seal (4) in position on oil cooler bonnet (1). Put clean engine oil on O-ring seal (4).
Show/hide table
Illustration 3 g00619597 - Align oil cooler bonnet (1) with oil cooler (2). Lubricate the bore of oil cooler (2) with clean engine oil. Install oil cooler bonnet (1) into the oil cooler.
- Lubricate the bore of oil cooler (2) with clean engine oil. Install elbow (3) into the oil cooler.
Show/hide table
Illustration 1 | g00619807 |
End By:
- Install the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Install".
Caterpillar Information System:
G3304 and G3306 Engines Governor
G3304 and G3306 Engines Pressure Sensor
3512B Marine Auxiliary Engine MID 111 - CID 1355 - FMI 04 Left Turbo Air Outlet Temp Sensor short to gnd
3512B Marine Auxiliary Engine MID 111 - CID 1355 - FMI 03 Left Turbo Air Out Temp Sensor open/short to +batt
3512B Marine Auxiliary Engine MID 111 - CID 1354 - FMI 04 Right Turbo Air Outlet Temp Sensor short to gnd
3512B Marine Auxiliary Engine MID 111 - CID 1354 - FMI 03 Right Turbo Air Out Temp Sens open/short to +batt
3512B Marine Auxiliary Engine MID 111 - CID 1353 - FMI 04 Engine Air Mnfld Outlet Temp Sensor short to gnd
3512B Marine Auxiliary Engine MID 111 - CID 1353 - FMI 03 Engine Air Mnfld Out Temp Sens open/short to +batt
3500B Engines Turbocharger - Install - Center Mounted Turbocharger
3406E On-Highway Engine Engine Oil Cooler - Install
SR4B Generators Exciter - Remove and Install
3500B Engines Turbocharger - Remove - Center Mounted Turbocharger
3406E On-Highway Engine Front Cover - Remove
3406E On-Highway Engine Front Cover - Install
On-Highway Engines Electronic PTO Installation and Application Guide PTO Configurations - Test
3406E On-Highway Engine Camshaft Position Sensor - Remove and Install
3406E On-Highway Engine Crankshaft Position Sensor - Remove and Install
3512B Marine Auxiliary Engine Emergency Stop Switch
3512B Marine Auxiliary Engine Starting Motor System
3512B Marine Auxiliary Engine Engine Control Switch (ECS)
3406E Marine Engine Cylinder Block
3512B Marine Auxiliary Engine Engine Sensor Open/Short Test
C-15, C-16 and C-18 Truck Engines Accessory Drive - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines Erratic GSC Operation - Troubleshoot