Turbocharger - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install new gasket (11) on exhaust manifold elbow (9) .
Show/hide table
Illustration 1 | g00520822 |
- Place a new gasket (not shown) on pipe (4) .
Show/hide table
Illustration 2 | g00520821 |
- Install pipe (4) and tighten bolts (10) onto turbocharger (7) .
- Install turbocharger (7) on elbow (9).
Show/hide table
Illustration 3 | g00520820 |
- Apply 5P-3931 Anti-Seize Compound on the studs that fasten exhaust manifold elbow (9) to turbocharger (7). Install nuts (8) and tighten the nuts to a torque of 44 N·m (33 lb ft).
- Install pipe (4) into hose (5) and tighten clamp (6) .
Show/hide table
Illustration 4 | g00520818 |
- Connect pipe (2) .
- Install clamp (3) .
- Install hose (1) and tighten the hose clamps on hose (1) .
Caterpillar Information System:
3114, 3116 and 3126 MUI Engine Governors Governor Servo (Types I, III, IV, V, VI, and VII)
315B Excavator Excavator Systems Boom Cylinder - Disassemble
315B Excavator Excavator Systems Boom Cylinder - Remove
318B Excavator Machine System Specifications Control Valve (Main)
315B Excavator Excavator Systems Stick - Install
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types V, VI, and VII)
345B, 345B Series II and W345B Series II Excavators Machine Systems Counterbalance Valve (Travel) - Disassemble - Series I
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types I and IV)
302.5 Mini Hydraulic Excavator Fuel Tank Cap and Strainer - Clean
3046 Engine For Caterpillar Built Machines Turbocharger - Remove
302.5 Mini Hydraulic Excavator Fuel System Water Separator - Drain
3046 Engine For Caterpillar Built Machines Fuel Transfer Pump - Install
320B Excavator Machine System Specifications Travel Motor
3114, 3116 and 3126 MUI Engine Governors Dashpot (Types I, III, IV, V, VI, and VII)
315B Excavator Excavator Systems Boom Cylinder - Assemble
317B Excavator Machine System and Attachment Specifications Bucket Linkage
3114, 3116 and 3126 MUI Engine Governors Governor Bias Spring (Most Types IV, V, and VI)
3114, 3116 and 3126 MUI Engine Governors Governor Bumper Spring (Some Type IV)
3114, 3116 and 3126 MUI Engine Governors Dual Horsepower (Type VI)
315B Excavator Excavator Systems Boom Cylinder - Install
318B Excavator Machine System Specifications Travel Motor Guard
315B Excavator Excavator Systems Boom - Remove
315B Excavator Excavator Systems Boom Bearings and Seals - Remove
315B Excavator Excavator Systems Boom Bearings and Seals - Install