Engine Stalls at Low RPM
- 单体喷油器
- 燃油供给
- 空气切断阀(若适用)或供气不畅
- 发动机低怠速
- 附属设备
- 检查电子控制模块(ECM)连接器 J1/P1 和 J2/P2 是否正确安装。 检查单体喷油器的连接器是否正确安装。 请参考故障诊断和排除 , "检查电气连接器 "部分。
- 使用卡特彼勒电子技师(ET)进行 "喷油器电磁阀测试",以确定 ECM 是否向所有喷油器电磁阀都励磁。
- 使用卡特彼勒 ET 进行"断缸测试",以找出不能点火的气缸。 有关正确的程序,请参考 故障诊断和排除 , "喷油器电磁阀 "部分。
- 检查燃油压力。 有关正确的程序,请参考 系统操作/测试和调整 手册。
- 检查燃油管路有无以下问题: 堵塞, 管路弯折 和 管路挤压 . 如果发现燃油管路有问题,请修理和/或更换管路。
- 检查油箱中有无会阻塞供油的异物。
Show/hide table
注意 持续盘车不要超过30秒。 再次盘车前,让起动马达先冷却2分钟。
- 如果执行了以下任一步骤,则向燃油系统充油:
- 更换燃油滤清器
- 维护低压供油油路
- 更换单体喷油器
注: 供油管路上的观察窗有助于诊断燃油中有无空气。
- 低温天气会对燃油特性造成不良影响。 有关改善低温操作条件下燃油特性的信息,请参考相应的 操作和保养手册 。
- 盘动发动机时,检查流经燃油滤清器之后的燃油压力。 有关正确的压力值,请参考 系统操作/测试和调整 手册。 如果燃油压力低,请更换燃油滤清器。 如果更换后燃油压力仍然偏低,请检查以下各项: 输油泵, 输油泵的连接 和 燃油压力调节阀 .
- 确认空气切断阀已打开。
- 检查进气系统中有无堵塞。 有关进气系统的信息,请参考 系统操作/测试和调整 手册。
检查低怠速设置。
检查所有附属设备有无可能引起发动机超负荷的问题。 修理或更换所有损坏的部件。
Caterpillar Information System:
3524B Engines for Off-Highway Trucks Poor Fuel Consumption
3500B Locomotive Engines Can Not Reach Top Engine RPM
3516B Engine for Caterpillar Built Machines ECM Will Not Accept Factory Passwords
3524B Engines for Off-Highway Trucks Engine Misfires, Runs Rough or Is Unstable
3500B Locomotive Engines Engine Cranks but Will Not Start
3500B Locomotive Engines MID 036 - CID 0444 - FMI 05 Start Relay open circuit
3500B Locomotive Engines MID 036 - CID 0339 - FMI 05 Engine Pre-lube Pressure Switch open circuit
3114, 3116 and 3126 Engines Excessive Valve Lash
3500B Locomotive Engines MID 036 - CID 0248 - FMI 02 Invalid CAT Data Link data
Installation and Initial Start-Up Procedure for G3516B and G3520B Engines{1000} Installation and Initial Start-Up Procedure for G3516B and G3520B Engines{1000}
G3304 and G3306 Engines Engine Design
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Accessory Drive (Front) - Remove
3524B Engines for Off-Highway Trucks Noise Coming from Cylinder
3524B Engines for Off-Highway Trucks Valve Rotocoil or Spring Lock Is Free
3524B Engines for Off-Highway Trucks Mechanical Noise (Knock) in Engine
3524B Engines for Off-Highway Trucks Excessive Engine Oil Consumption
3500B Locomotive Engines System Overview
3524B Engines for Off-Highway Trucks Programming Parameters
3512B Petroleum Engines with the ADEM 2 Electronic Control Module System Configuration Parameters
3500B Locomotive Engines Factory Passwords Worksheet
3500B Locomotive Engines Customer Parameters Worksheet
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Engine Monitoring System - Programmable
3406E Generator Set Engines Reference Numbers
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Electronic Display Module - Optional