Fuel Injector - Remove
Start By:
- Remove the rocker shaft assembly.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove wire (2) from the groove in the rocker arm base. Disconnect the wire from the connector of the fuel injector.
Show/hide table
Illustration 2 g00606052 - Remove bolt (3) and fuel injector clamp (4) from the cylinder head and from the fuel injector.
Show/hide table
Illustration 3 g00605616 - Use a pry bar to raise fuel injector (1) out of the cylinder head.
Show/hide table
Illustration 4 g00605617 - Remove fuel injector (1).
Show/hide table
| |
| Illustration 1 | g00605614 |
Caterpillar Information System:
3114, 3116 and 3126 Engines Excessive Engine Oil Consumption
G3612 and G3616 Engines Water Lines - Remove and Install
G3612 and G3616 Engines Water Manifold - Remove and Install
3612 and 3616 Engines Water Pump Seal - Install
3500B Engines Rocker Shaft - Assemble
3500B Engines Rocker Shaft - Disassemble
3612 and 3616 Engines Water Pump Seal - Remove
3612 and 3616 Engines Water Pump - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner - Install
3612 and 3616 Engines Water Pump - Disassemble
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Electric Starting Motor
G3612 and G3616 Engines Water Pump - Install
3126B Marine Engine Glossary of Electronic Control Terms
G3304 and G3306 Engines Engine Design
3512B Marine Auxiliary Engines Fuel Injector - Install
3114, 3116 and 3126 Engines Excessive Fuel Consumption
3500B Engines Exhaust Manifold - Remove and Install
3512B Marine Auxiliary Engines Cylinder Head - Remove
3500B Locomotive Engines MID 036 - CID 0011 - FMI 05 Injector Cylinder 11 open circuit
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Accessory Drive (Front) - Remove
G3304 and G3306 Engines Engine Design
Installation and Initial Start-Up Procedure for G3516B and G3520B Engines{1000} Installation and Initial Start-Up Procedure for G3516B and G3520B Engines{1000}
3500B Locomotive Engines MID 036 - CID 0248 - FMI 02 Invalid CAT Data Link data
3114, 3116 and 3126 Engines Excessive Valve Lash