Illustration 1 | g00420185 |
The control pedal is located to the right of the travel levers if the machine is not equipped with a blade.
Illustration 2 | g00420186 |
The control pedal is located to the left of the travel levers if the machine is equipped with a blade.
Illustration 3 | g00375456 |
(1) Lock pin (A) LOCKED position (B) ONE-WAY FLOW position (C) TWO-WAY FLOW position |
The pedal allows modulation of the implement speed. To cause the implement to move faster, push down on the pedal more.
The pedal has three positions. Position (B) allows hydraulic oil to flow in one direction (hydraulic hammer). Position (C) allows hydraulic oil to flow in both directions (hydraulic shear and offset boom). Use LOCKED position (A) when the implement does not need to be used.
When the pedal is in ONE-WAY FLOW position (B) the pedal can only be depressed forward.
When the pedal is in TWO-WAY FLOW position (C) the pedal can be depressed forward and backward.
Insert lock pin (1) into LOCKED position (A) when the implement is not being used. This will prevent any unexpected operation of the implement.
Illustration 4 | g00291805 |
Note: To prevent lock pin (1) from being pulled out, insert pin (2) through notch (3) and turn lock pin (1) counterclockwise by 1/4 turn.