3512B Petroleum Engines with the ADEM 2 Electronic Control Module Caterpillar


MID 036 - CID 0827 - FMI 04 Left Exhaust Temperature short to ground

Usage:

3512B 2AF
Conditions Which Generate This Code:

The Electronic Control Module (ECM) reads a signal voltage that is below 0.2 VDC for one second. The ECM has been powered for three seconds. The diagnostic codes 263-03 and 263-04 are not active.

System Response:

The CID-FMI is logged in memory. The CID-FMI may be viewed on a display module or the Caterpillar Electronic Technician (ET). The ECM flags the left exhaust temperature as invalid data. The engine monitoring system is disabled for left exhaust temperature.

Test Step 1. Perform the following diagnostic procedure: Engine Sensor Open/Short Test

Results:

  • OK - STOP

  • REPAIRED, OK - STOP

Caterpillar Information System:

3512B Petroleum Engines with the ADEM 2 Electronic Control Module MID 036 - CID 0827 - FMI 03 Left Exhaust Temperature open/short to +batt
3500B Marine Engines MID 036 - CID 0650 - FMI 02 Harness Code Unknown
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0542 - FMI 02 Unfiltered Engine Oil Pressure misinstalled
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0444 - FMI 05 Start Relay open circuit
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Housing (Front) - Install
3500B Engines Aftercooler - Remove and Install
3304B and 3306B Engines for Caterpillar Built Machines Engine Balancer Shaft Bearings - Remove and Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Housing (Front) - Remove
3500B Engines Fuel Transfer Pump - Install
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0337 - FMI 02 Incorrect Remote E-Stop Switch inputs
3500B Marine Engines MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
3126B Engine for Caterpillar Built Machines Main Bearing Journal
3500B Marine Engines Analog Sensor Supply
3500B Marine Engines Digital Sensor Supply
3176C and 3196 Engines for Caterpillar Built Machines Fuel Temperature Sensor - If Equipped
3126B Engine for Caterpillar Built Machines Coolant Temperature Sensor
3126B Marine Engine Inlet Air Temperature Sensor
3500B Marine Engines Rotation Enable Circuit
3126B Industrial Engine Monitoring System
3500B Marine Engines CAT Data Link
3612 and 3616 Engines Engine Lifting Bracket - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Shutoff Solenoid
3612 and 3616 Engines Engine Support - Remove and Install
3500B Marine Engines System Overview
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.