Crankshaft Rear Seal - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the back of the cylinder block and the mating surface of the backplate.
- Install crankshaft rear seal (3) on the cylinder block.
Show/hide table
Illustration 1 | g00578148 |
- Put a bead of 4C-9612 Silicone Sealant around the bolt holes and the face of the cylinder block.
- Position backplate (2) on the rear of the engine.
Show/hide table
Illustration 2 | g00578100 |
- Install bolts (1) that fasten backplate (2) on the engine. Tighten the bolts to the following torque:
3003 Engine ... 50 N·m (37 lb ft)
3013, 3014 and 3024 Engines ... 15 N·m (11 lb ft)
End By: Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Caterpillar Information System:
3500 and 3500B Engines Control Panel
3406E On-Highway Engine Connecting Rod Bearings - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Filter Base
3406E On-Highway Engine Connecting Rod Bearings - Remove
3408E and 3412E Engines for Caterpillar Built Machines Air in Fuel - Test
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Remove
3408E and 3412E Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
G3500 Engines Crankshaft Main Bearings - Install
3406E On-Highway Engine Pistons and Connecting Rods - Remove
3500B High Displacement Generator Set Engines Model View Illustrations
3600 Distillate Fuel Engines Product Description
Generator Set Control Panel for Switchgear Conversion General Information
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger - Install
3406E On-Highway Engine Crankshaft Main Bearings - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines SP Fault Code - Troubleshoot
G3500 Engines Camshaft - Remove
G3500 Engines Camshaft - Install
3612 and 3616 Engines Exhaust Manifold
3176B Industrial Engine Engine Description
3176C and 3196 Engines for Caterpillar Built Machines Inlet Manifold Pressure - Test
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Transfer Pump
3408E and 3412E Engines for Caterpillar Built Machines Flywheel - Remove
3176B Industrial Engine Gauges and Indicators