Flywheel Housing Runout
Usage:
8T5096 Dial Indicator Group Installed
Face Runout (Axial Eccentricity) Of The Flywheel Housing:
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at 0.0 mm (.000 in.) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than 0.30 mm (.012 in.), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
G379, G398 & G399 ENGINES Flywheel Runout
G379, G398 & G399 ENGINES Flywheel Housing
G379, G398 & G399 ENGINES Flywheel
G379, G398 & G399 ENGINES Front Accessory Drive
G379, G398 & G399 ENGINES Vibration Damper
G379, G398 & G399 ENGINES Bearing Surface (Journal) For Main Bearings
G379, G398 & G399 ENGINES Bearing Surface (Journal) For Connecting Rods
G379, G398 & G399 ENGINES Main Bearings
G379, G398 & G399 ENGINES Connecting Rod Bearings
G379, G398 & G399 ENGINES Connecting Rod
G379, G398 & G399 ENGINES Crankshaft
G379, G398 & G399 ENGINES Pistons And Rings
G379, G398 & G399 ENGINES Flywheel Housing Bore
G379, G398 & G399 ENGINES Prelube Motor Relay 8L6347 Relay (24V or 32V Direct Current):
G379, G398 & G399 ENGINES Prelube Pump Motor 2N7644 (H184C Viking Pump Co.):
G379, G398 & G399 ENGINES Oil Pressure Switches
G379, G398 & G399 ENGINES Alternators
G379, G398 & G399 ENGINES Alternator Regulators
G379, G398 & G399 ENGINES Starter Motor
G379, G398 & G399 ENGINES Magnetic Switch
G379, G398 & G399 ENGINES Starter Solenoids
D342 INDUSTRIAL & MARINE ENGINES Systems Operation
D342 INDUSTRIAL & MARINE ENGINES Testing And Adjusting
D342 INDUSTRIAL & MARINE ENGINES Introduction