Fuel Transfer Pump - Remove
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect hose assemblies (1) and (2). Plug and cap all openings in order to prevent debris and contamination from entering the system.
- Remove bolts (3) and fuel transfer pump (4).
Show/hide table
Illustration 2 g01039865 - Check the condition of O-ring seal (5) on fuel transfer pump (4). If the O-ring seal is worn or damaged, use a new part for replacement.
Show/hide table
| |
| Illustration 1 | g00488104 |
Caterpillar Information System:
P16, P20, P25, P28, P40 and P60 Pulverizers Pulverizer Cylinder
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 441 FMI 12 Electronic Governor Relay Failed - Test
3306C Truck Engine Crankshaft Front Seal - Remove
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 442 FMI 12 Generator Fault Relay Failed - Test
3406C (PEEC III) Truck Engine Shutoff Solenoid
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 334 FMI 4 Spare Output Voltage Below Normal - Test
3306C Truck Engine Connecting Rod Bearings - Remove
3306C Truck Engine Connecting Rod Bearings - Install
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 334 FMI 3 Spare Output Voltage Above Normal - Test
3600 Heavy Fuel Engines Derating Strategy
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 336 FMI 2 Switch (Engine Control) Incorrect Signal - Test
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 443 FMI 12 Crank Termination Relay Failed - Test
G3612 and G3616 Engines Air Inlet and Exhaust System
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
3612 and 3616 Fast Vessel Engines Alarms and Shutoffs
3600 Heavy Fuel Engines Exhaust Manifold - Inspect
3306C Engines for Caterpillar Built Machines Engine Design
3406E On-Highway Engine Electronic Unit Injector Sleeve - Install
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 445 FMI 12 Run Relay Failed - Test
3406E On-Highway Engine Electronic Unit Injector Sleeve - Remove
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test
3306B Industrial Engine Fuel Injection Pump