Pulverizer Cylinder
Show/hide table
 | |
| Illustration 1 | g00479669 |
The arm cylinder is a double acting cylinder. Hydraulic oil enters port (2). The oil flows into area (4). Pressure increases as the oil moves into area (4). The pressure buildup causes the cylinder head (5) to extend.
Hydraulic oil enters port (1). The oil flows into area (3). Pressure increases as the oil moves into area (3). The pressure buildup causes the cylinder head (5) to retract.
Rod end (6) is fixed to the crusher housing. Head end (5) is movable with the arm.
Hydraulic oil flows through the rod during extension of the arm cylinder. There are no hoses that are connected to the cylinder head. These hoses would not have protection. This configuration allows all hoses to have protection inside the pulverizer housing.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 441 FMI 12 Electronic Governor Relay Failed - Test
3306C Truck Engine Crankshaft Front Seal - Remove
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 442 FMI 12 Generator Fault Relay Failed - Test
3406C (PEEC III) Truck Engine Shutoff Solenoid
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 334 FMI 4 Spare Output Voltage Below Normal - Test
3306C Truck Engine Connecting Rod Bearings - Remove
3306C Truck Engine Connecting Rod Bearings - Install
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 334 FMI 3 Spare Output Voltage Above Normal - Test
3600 Heavy Fuel Engines Derating Strategy
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 336 FMI 2 Switch (Engine Control) Incorrect Signal - Test
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
3406E On-Highway Engine Air Compressor - Remove and Install
3406E On-Highway Engine Fuel Transfer Pump - Remove
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 443 FMI 12 Crank Termination Relay Failed - Test
G3612 and G3616 Engines Air Inlet and Exhaust System
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
3612 and 3616 Fast Vessel Engines Alarms and Shutoffs
3600 Heavy Fuel Engines Exhaust Manifold - Inspect
3306C Engines for Caterpillar Built Machines Engine Design
3406E On-Highway Engine Electronic Unit Injector Sleeve - Install
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 445 FMI 12 Run Relay Failed - Test
3406E On-Highway Engine Electronic Unit Injector Sleeve - Remove
Electronic Modular Control Panel II (EMCP II) for EUI Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test