Fuel Injection Control Linkage
Show/hide table
Illustration 1 | g00287421 |
Right Side View |
(1) Lubricate the bearing and the lip seal of the flange assembly with clean engine oil.
(2) Diameter of shaft at bearings ... 19.000 ± 0.020 mm (.7480 ± .0008 inch)
(3) Bore in bearings for shaft assembly ... 19.044 ± 0.007 mm (.7498 ± .0003 inch)
(4) The minimum end play for the shaft assembly is the following value. ... 1.5 mm (.06 inch)
(5) The bearings are installed in the rear of the cylinder block at the following depth. ... 29.0 ± 1.0 mm (1.14 ± .04 inch)
Show/hide table
Illustration 2 | g00287422 |
Rear View |
(6) Tighten the nut that holds the lever to the rack to the following torque. ... 17 ± 7 N·m (13 ± 5 lb ft)
(7) Rod assemblies center to center length after adjustment. ... 500.00 ± 0.25 mm (19.685 ± .001 inch)
Caterpillar Information System:
3618 Engine Fuel Pressure Control Valve
3618 Engine Fuel Injector Mechanism
3612 and 3616 Engines Water Pump
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Refill Capacities
G3612 and G3616 Engines Flywheel
G3300 Engines Engine Air Precleaner - Clean
3612 and 3616 Engines Water Temperature Regulator
3612 and 3616 Engines Water Temperature Regulator
3500B Engines for Caterpillar Built Power Modules Water Temperature Regulator
3612 and 3616 Engines Fuel Filter Housing
3512 and 3516 EUI Engines for Caterpillar Built Machines Air Starting System
3618 Engine Fuel Transfer Pump
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Cooling System Coolant (DEAC) - Change
G3606 and G3608 Engines Camshaft Bearing Position
G3606 and G3608 Engines Camshaft Bearings
G3606 and G3608 Engines Cylinder Block
3618 Engine Compression Release Valve
3618 Engine Fuel Injection Lines
3612 and 3616 Engines Priority Valve
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
3406E and 3456 Industrial Engines Rocker Shaft
3406E Truck Engine Engine Oil Filler
Torque Specifications Straight Thread O-Ring Fittings
3618 Engine Cylinder Liner