Auxiliary Water Pump - Sea Water
Show/hide table
图 1 | g00854143 |
(1) 螺塞
拆下螺塞以充充油泵。
(2) 螺塞
将螺塞安装于泵的进水口。 锌连杆和螺塞安装在此处的出水口。 按照以下步骤将锌连杆组装进螺塞。
- 将 9S-3263 螺纹锁固定胶 涂抹在连杆的肩部。 不要在连杆的螺纹上涂抹密封胶。
- 拧紧连杆。
扭矩 ... 7 ± 3 N·m (62 ± 26 lb in)
(3) 密封圈
将清洁的发动机机油涂在密封唇上。 如图所示,安装密封圈。
(4) 套圈
将 4C-9507 固定剂 涂抹在轴和套圈之间。
(5) O 形密封圈
组装之前,在密封件上涂抹清洁的发动机机油。
(6) O 形密封圈
组装之前,在密封件上涂抹清洁的发动机机油。
(7) 螺母
- 扭矩 ... 135 至 200N·m (100 至 148lb ft)
(8) O 形密封圈
组装之前,将清洁的发动机机油涂在密封唇上。
(9) 螺母
-
将 7M-7456 固定胶 涂抹在螺母的螺纹上。 如果开口销不能安装,则顺时针转动螺母,直到螺母中最近的插槽对准轴内的孔。
- 扭矩 ... 135 至 175N·m (100 至 129lb ft)
(10) 垫片
- 安装垫片,以便获得孔板与叶轮之间以下的间隙。 ... 0.18 至 0.23 mm (0.007 至 0.009 in)
Show/hide table
垫片表:     | ||
垫片     | 厚度     | |
5N-9015 垫片     | 0.38 mm (0.015 in)     |
|
5N-9016 垫片     | 0.25 mm (0.010 in)     |
(11) 密封圈和水封
- 将干净的水放在密封件和密封圈上。
- 用手加压,将密封组件安装到轴上。 按下密封件,直到密封件组件中的碳表面与陶瓷密封件的光滑表面相接触。
(12) 密封组件
- 将清洁的水放在密封组件内。
- 用手加压,将密封组件安装到轴上。 按下密封件,直到密封件组件中的碳表面与陶瓷密封件的光滑表面相接触。
Caterpillar Information System:
3176C and 3196 Marine Engines Service Meter
3408E and 3412E Industrial Engines Tachometer Calibration Chart
3500B Engines Auxiliary Water Pump - Sea Water
3176C and 3196 Industrial Engines Magnetic Pickup
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Engine Oil Pan
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Engine Oil Pan
3500B Engines Coolant Level Switch
3176C and 3196 Industrial Engines Speed Sensing Loss Alarm
3176C and 3196 Marine Engines Gear Group (Front)
3500B Engines for Caterpillar Built Power Modules Coolant Level Sensor
3176C and 3196 Engines for Caterpillar Built Machines Crankshaft Seal (Front)
3500B Engines Power Take-Off Clutch - Front
3500B Engines Air Inlet and Exhaust Lines
3306B Industrial Engine Tachometer
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Air Starting Motor
G3304 and G3306 Engines Air Starting Motor Pressure Regulating Valve
3500B Engines Radiator Mounting
3176C and 3196 Marine Engines Fuel Filter and Water Separator
G3406 and G3412 Generator Set Engines Coolant Level Sensor
3126 Truck Engine Inlet Air Temperature Sensor
3176C and 3196 Marine Engines Transmission Oil Pressure Sensor
3176C Engine Engine Oil Pressure Sensor
3176C Engine Fuel Pressure Sensor
3500B and 3500B High Displacement Generator Set Engines Engine Design